Ten Tips for Controlling Moisture Levels in Your Home

By Jeffrey C. May —

Mold can pose serious health risks – especially for people with allergies and asthma. The key to controlling mold growth is reducing moisture, whether from leaks, high humidity or variations in temperature in your home.

Below are ten tips to help you keep your home drier and thus mold free.

  1. Dry up drips. Even a small water leak can develop into a major mold problem, so check pipes under sinks, and behind your washing machine and refrigerator (if it has a water line). Repair leaks right away.
  2. Mold can pose serious health risks – especially for people with allergies and asthma. The key to controlling mold growth is reducing moisture, whether from leaks, high humidity or variations in temperature in your home.
  3. Watch the hot-water tank. Put a battery-operated floorwater alarm near your hot-water tank, so you’ll be alerted if the tank starts to leak. If you have a central alarm system, consider having a floor-water alarm tied into the system. If you have a gas-fired hot-water heater, plan to replace it right before the warranty expires. Electric hot-water heaters tend to last longer than their warranty, but still, keep an eye on the warranty date.
  4. Control the relative humidity below-grade. Mold growth doesn’t always require standing water. Some molds can begin to grow when the relative humidity (RH) is over 80%.As air cools, its RH rises. Below-grade (below ground level) spaces like basements and crawl spaces are naturally cool and damp, so the RH must be adequately controlled.Use a thermo-hygrometer to measure the RH. The RH should be kept at or below 50% in unfinished basement spaces and in crawl spaces, and below 60% in finished basement spaces.

    Between mid-April and mid-October, add dehumidification as needed, even if your finished basement has air conditioning. Be sure that your dehumidifier is adequate for the space, and attach the machine to a condensate pump, so that it can drain into a sink or to the exterior. That way, you won’t have to empty the reservoir (when the reservoir is full, a dehumidifier shuts off).

    In the winter, you do not need to dehumidify an unfinished basement, but a finished basement must be kept consistently warm, whether in use or not, with the thermostat set at a minimum of 57o F.

    If you have an indirect-fired, hot-water system or tankless system (i.e. the boiler heats the domestic hot water), this will help control the RH, because the boiler operates year-round and produces heat as it does so.

  5. Don’t over-humidify above grade: In the winter, we don’t open windows and doors that much, so moisture can build up in a house in above-grade rooms. If you have an exhaust fan over your cook stove that vents to the exterior, use the fan whenever you cook or bake, and try to cook and bake at the same time.After showering or bathing, operate the exhaust fan in the bathroom. In addition, leave the door open and operate an oscillating fan in the bathroom to help dry surfaces.If you have a central humidification system, keep the RH in habitable rooms under 40% (lower in extreme cold). The same holds true if you use a portable humidifier in any particular room. Always measure the RH with a thermo-hygrometer.

Read the complete article in the April 2018 issue of Healthy Indoors Magazine at: https://hi.healthyindoors.com/i/971754-hi-april-2018/25

Views: 52

Tags: moisture, mold

Comment

You need to be a member of Home Energy Pros Forum to add comments!

Join Home Energy Pros Forum

Comment by Franco Oyuela on Tuesday

Tips for Controlling Moisture Levels in Your Home

1. Dry up the drips
2. Don’t be sloppy when watering your indoor plants
3. Watch the hot water tank
4. Control the relative humidity below-grade
5. Don’t over-humidify above grade
6. Keep your exterior closet(s) warm
7. Don’t keep some rooms cold while you heat other rooms
8. Isolate your crawl space
9. Don’t introduce unnecessary amounts of moisture into your attached garage

Forum Discussions

Exterior green cladding

Started by Luis Hernandez in General Forum Apr 12. 0 Replies

Faces & Places of HPC19

Started by Diane Chojnowski in General Forum Apr 5. 0 Replies

high rise humidity

Started by Steve Nations in HVAC. Last reply by Dennis Heidner Apr 3. 7 Replies

Follow the action at #HPC19

Started by Diane Chojnowski in General Forum Apr 2. 0 Replies

Unvented Roof Assembly

Started by Patrick Michaelyan in General Forum. Last reply by Wallacebastien Mar 30. 6 Replies

Technology and Customer Service

Started by Kelly Caplenas in General Forum. Last reply by Franco Oyuela Mar 25. 1 Reply

Latest Activity

Emily Ambrose's blog post was featured
20 minutes ago
Corbett Lunsford's video was featured

Chemistry and Building Performance with HOMEChem's Dr. Richard Corsi

Dr. Corsi has been experimenting with indoor chemistry for decades, and his findings are NOT what you'd expect. Listen to the man. Learn more at: https://HomeDiagnosis.tv/homechem
3 hours ago
Diane Chojnowski posted a blog post
4 hours ago
Emily Ambrose posted a blog post
4 hours ago
Matt Worthy posted photos
13 hours ago
Brandon Price replied to Brandon Price's discussion For Sale: Minneapolis Blower Door, Duct Blaster and 2xDG-700. in the group Energy Auditing Equipment for Sale, Trade or to Purchase
13 hours ago
Brandon Price added a discussion to the group Energy Auditing Equipment for Sale, Trade or to Purchase
Thumbnail

For Sale: Minneapolis Blower Door, Duct Blaster and 2xDG-700.

The Energy Conservatory Minneapolis Blower Door, Duct Blaster, 2 DG700’s and a never used Testo 310…See More
14 hours ago
Profile IconBrandon Price and Gava Sky joined allen p tanner's group
Thumbnail

Energy Auditing Equipment for Sale, Trade or to Purchase

Discuss the pros and cons of the equipment you are interested in prior to purchase. Post equipment…See More
14 hours ago

© 2019   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service