Looking for some insight on proper insulation methods. We will be building a raised wood framed floor above an existing concrete slab garage floor. Converting the garage into a bedroom. The heat will be hydronic in floor radiant, we will have 9-10" from concrete to the top of sub floor.Current thoughts are EPS on the floor sealing all seams and perimeter W/ Roxul bats in the joist cavity then a layer of radiant under the sub floor.

Views: 242

Reply to This

Replies to This Discussion

Matthew, if you use 2 lb EPS or 25psi in two layers staggered layers 4" overall then you can put a 2x4 flat for bearing. This allows for smaller joist while giving you R20 minimum. Then between the joist I would put any batt insulation but put a foil bubble foil product to reflect the heat upward with pex tubing. This will be the most efficient for least cost. The inability to staple upward to the subfloor is why I recommend the foil bubble foil. Also tape the seams. THE CLOSER to the subfloor with the foil the better.

I have done this before. We did not use hydronic heat or radiant barrier. We used all EPS foam leaving a small half inch gap between foam and wood framing to foam in w a can. Yes we cut and filled the whole framed cavity as well as a 2" EPS continuous taped under everything. 

Just make sure the EPS is highest PSI rated possible. Usually the 2" comes in the highest PSI rating. 

Pay attention to a vapor barrier. You will have one'ish the bottom so make sure the cavity can breath into conditioned space. So put the radiant barrier reflecting upward on top of the EPS. Like what Dave Taylor said. Dont sandwich the cavity w 2 vapor barriers.

Roxul is amazing stuff?

I ment Roxul is amazing stuff!

Thank you for your insight.

Proper insulation methods:

Blanket: Batt and Roll Insulation
Fiberglass Batt Insulation Characteristics
Concrete Block Insulation
Foam Board or Rigid Foam
Insulating Concrete Forms
Concrete Form Association.
Loose-Fill and Blown-In Insulation

RSS

Forum Discussions

REALLY????

Started by Danny Gough in HVAC. Last reply by Danny Gough on Saturday. 12 Replies

How to Insulate Exposed Outdoor Ductwork?? Help

Started by Daniel Baur-McGuire in General Forum. Last reply by Bradford E. White on Friday. 7 Replies

Where to spend my marketing dollars?

Started by Trip Smith in Marketing. Last reply by Building Performance Institute on Tuesday. 10 Replies

Easy Tests for HVAC during audit

Started by Craig Bird in Weatherization. Last reply by John White May 9. 19 Replies

Water heater ventilation question

Started by Luis Hernandez in General Forum. Last reply by Dennis Heidner May 8. 23 Replies

Polar vortex photos of ice forming INSIDE homes!

Started by Diane Chojnowski in General Forum. Last reply by Michael Cuomo May 4. 1 Reply

LEED for Homes Green Rater Training

Started by Ryan Moore in Training. Last reply by Michael Cuomo May 3. 1 Reply

Latest Activity

Enervest Solar is now a member of Home Energy Pros Forum
1 hour ago
John White posted blog posts
6 hours ago
Dennis Heidner replied to John S. Rodenhizer's discussion Using radiant barriers as duct insulation, Aka "Bubble wrap" What value do you assign for R-value?
"Read the manufacturers claims and installation steps closely  The foil needs a dead…"
9 hours ago
Danny Gough replied to Danny Gough's discussion REALLY????
"As I have read through everyone's excelent responses, it has caused me to reassess my…"
Saturday
Tim O'Brien replied to Danny Gough's discussion REALLY????
"Bradford - I have seen single family homes with ducted central AC or heat pump hold enough water…"
Friday
Brett Little posted an event

How to Make Money by Cutting Your Home's Carbon Footprint, Heating Bill, and Electricity Bill to Zero - Free CE Webinar at Webinar Online

June 12, 2019 from 12pm to 1:15pm
How to make money by cutting your home's carbon footprint, heating bill and electricity bill to…See More
Friday
Emily Ambrose posted a blog post
Friday
Building Performance Institute commented on Emily Ambrose's blog post 4 Signs Your Website Is In Need of A Refresh
"Excellent food for thought! Thank you!"
Friday

© 2019   Created by Building Performance Association   Powered by

Badges  |  Report an Issue  |  Terms of Service