Angela Bowman's Comments

Comment Wall (3 comments)

You need to be a member of Home Energy Pros Forum to add comments!

Join Home Energy Pros Forum

At 5:31pm on April 7, 2011, Aaron Lund said…

Your'e question is a few months old, so I don't know if its still relevant:

 

"Wondering about hydronic vs. straight electric baseboard heaters: which is more energy efficient?"

 

I'll give my two cents anyway. 

 

The electric baseboard heaters will be 100% efficient.  No energy is wasted by an electric resistance coil.  Unfortunately, the electricity generating process is only about 35% efficient.  A lot of energy is wasted at the power plant and along the transmission lines. Also, electric heat is typically around 3 times as expensive as natural gas heat.

 

A hydronic heater (which requires a boiler) will be approximately 80% to 90% efficient, depending on the quality of the boiler you purchase.  There may be some minor additional inefficiencies if hot water lines aren't well insulated when passing through unconditioned spaces, etc. 

 

Taking into account the energy losses that occur during electricity generation and transmission, I would say that the hydronic system will be more efficient.  Please note, none of my analysis includes the energy required for extraction and refining, which applies to both electricity and gas.  I'm assuming the front end energy used for extraction is similar for both energy sources.

 

Hope this helps.  I would go with the hydronic system.  It might cost more to install than an electric system, but its cheaper to operate, and I don't like feeling like I can't do anything about the large amounts of electricity wasted before it even reaches my home.

At 5:14pm on April 7, 2011, Aaron Lund said…

Hey Angela,

Sorry for the delayed response.  This is my first time actually logging in here (except to join).  The new job is going great.  I'm really working exclusively on commercial buildings now.  I kind of miss working on homes.

I'm gonna go check out your blog.

At 5:19pm on November 5, 2010, Tom White said…
Angela--welcome to Home Energy Pros. It's good to see you here. Thanks for joining the conversation. Tom

Latest Activity

Chris Dorsi posted an event
Thumbnail

2018 Habitat X Summer National Conference at Big Sky Montana

June 27, 2016 to June 29, 2016
The 2018 Habitat…See More
8 hours ago
Stuart Langley liked David Byrnes's blog post Strategies for Hiring and Interviewing for Home Performance Professionals
12 hours ago
Kevin Miller replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"Visual inspection can only confirm the presence of mold, not the absence.   That said,…"
15 hours ago
Armand C Magnelli replied to Don Fugler's discussion joining ducts in the group HVAC
"I often suggest pop-rivets as an alternative to sheet metal screws for both clothes dryer duct work…"
15 hours ago
Kevin Miller replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"Sampling would be primarily to verify 'Condition 1' or 'Normal Fungal Ecology'…"
15 hours ago
Daniel Cullen joined Building Performance Institute's group
Thumbnail

Building Performance Institute (BPI)

BPI is the nation's premier standards development, quality assurance and credentialing organization…See More
15 hours ago
Daniel Cullen replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"Can anyone tell me exactly HOW mold sampling impacts the mold remediation process or protocol? Why…"
15 hours ago
Daniel Cullen joined Bob Krell's group
Thumbnail

Healthy Indoors (IAQ)

The Healthy Indoors group is focused on indoor air quality (IAQ), mold, moisture control, radon,…See More
15 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service