Quickest way to Field-check you Model 3 Flow Sensor!

I think the question I get asked the most is, well I dunno know, it happens a lot, enough that I would remark on it – a lot of people come up to me and they say “How do I know if my flow sensor is positioned within spec?“

My answer’s always the same, I say: “Listen. Luckily we don’t have to go all the way back to the Civil War to answer this…” ¹

The truth is, most never check, but here’s a quick easy way to ensure your Minneapolis fan’s flow sensor’s positioned properly in the field. So easy in fact that you’ll do it every time!

The spec for a Model 3 fan is between 3/16″ (4.7mm) and 5/16″ (7.9mm). See page 58 and 59 of the Operation Manual.

Lay the fan flat so flow sensor hub is up. Using the fan frame’s cross bar, use a measuring tape, simply measure the gap!

http://www.bluegreengroup.ca/site/wp-content/uploads/2013/09/P1050209-e1380550228677.jpg

Easy as pie: slap your cross bar on the back face of the fan carcass so it spans the fan housing and measure the gap. I used my grandfather’s T-square for the picture above, but you can use your measuring tape!

http://www.bluegreengroup.ca/site/wp-content/uploads/2013/09/P1050211-e1380551422921.jpg

And the reading is 2/8″ AKA 4/16″ or 1/4″! We’re in the house!

If your fan is not in spec, the fix is super easy, you’ll have to loosen a bolt and move the motor in the mounting bracket till its within. You can learn more about it in this article I wrote a while back for Homer Energy magazine called Pimp My Blower Door: A blower door make-over.

Foot note:

¹ Sorry for the cheesy homage to Tom Waits.

Views: 115

Comment

You need to be a member of Home Energy Pros Forum to add comments!

Join Home Energy Pros Forum

Latest Activity

Dannie Jackson liked Barry NewDelman's discussion Help your Clients save, THEN do what you do best
18 minutes ago
Dannie Jackson replied to Barry NewDelman's discussion Whats the Consensus of this group Define "Energy Efficiency" in the group Energy Efficient Design
"Design wise I would say that energy efficiency is defined by the Btu / square foot.  This is…"
21 minutes ago
Dannie Jackson joined Chris Laumer-Giddens's group
Thumbnail

Energy Efficient Design

Energy efficiency starts at the drafting table...How architects and designers can help buildings…See More
21 minutes ago
Dannie Jackson liked Chris Laumer-Giddens's group Energy Efficient Design
47 minutes ago
Dannie Jackson posted a blog post
1 hour ago
Dannie Jackson liked Home Performance Coalition's blog post Building a Market for High-Performing Homes
2 hours ago
Summer Reyes posted a blog post
17 hours ago
Oliver Periman is now a member of Home Energy Pros Forum
yesterday

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service