The finer points of thermostats are actually much more complicated than any published article covers. You must study each premium thermostat individually. If it does not have settings for swing, deadband, fan delays, early recovery, proper setbacks, etc., it's not really of good use. Dual fuel setups are even more complicated because you must decide whether to use the thermostat or the fossil fuel controller function for balance point control. You must also decide on an economic or thermal balance point.  
  
If you actually live in the house, you may adjust a dual fuel setup to your preferred balance point. If you are an installer, you may be tempted to guess at a balance point, the same as guessing at the sizing of the HVAC units. If you are a designer, you will have your own methods for sizing and setup, with lots of room for discussion, and possibly,  imprecision. A homeowner without degrees in physics, chemistry, and business is at a total loss to understand their home climate system today!  
  
Manual thermostat control always results in the lowest costs and optimum comfort. No thermostat out there can compete with a trained human! The Nest thermostat has serious flaws, as does its competitor, the Honeywell Prestige thermostat. The ideal thermostat for all setups has yet to be produced or exist.   
  

Views: 399

Tags: dual, fuel, honeywell, nest, thermal, thermostat

Comment

You need to be a member of Home Energy Pros Forum to add comments!

Join Home Energy Pros Forum

Comment by Tom DelConte on February 28, 2012 at 11:19am

Also: Cable giant Comcast plans to offer a smart thermostat: http://gigaom.com/cleantech/comcast-to-offer-smart-thermostat-servi...

Comment by Tom DelConte on February 27, 2012 at 1:27pm

Opower is an important development is temperature and power control, but your electric co. must cooperate: http://www.greentechmedia.com/articles/read/Opower-Channels-Home-Ef... . 

Latest Activity

Don Fugler replied to Don Fugler's discussion joining ducts in the group HVAC
"Brendan, Thanks for that response. Because of your warning, I just went down to the basement and…"
3 hours ago
Brendan Reid replied to Don Fugler's discussion joining ducts in the group HVAC
"Hi Don, Summary: DRYER VENT: screws bad idea, possibly prohibited by code. METAL DUCT: must be…"
3 hours ago
Profile IconBrendan Reid and David Butler joined Allison A. Bailes III's group
Thumbnail

HVAC

HVAC design, Manuals J, S, T, & D, Duct leakage, Air flow, ENERGY STAR new home requirements,…See More
3 hours ago
Profile IconSean Wiens and David Butler joined Chris Laumer-Giddens's group
Thumbnail

Energy Efficient Design

Energy efficiency starts at the drafting table...How architects and designers can help buildings…See More
12 hours ago
Profile IconSean Wiens and David Butler joined Mark Richardson's group
Thumbnail

Renewable Energy

This group will focus on the issues associated with incorporating renewable energy sources like…See More
12 hours ago
Al Tibbs posted photos
12 hours ago
Al Tibbs replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"In any case where there is visible mold present, I would begin with a thorough VISUAL assessment of…"
13 hours ago
Al Tibbs joined Bob Krell's group
Thumbnail

Healthy Indoors (IAQ)

The Healthy Indoors group is focused on indoor air quality (IAQ), mold, moisture control, radon,…See More
13 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service