HI, I am looking for:
Minneapolis blower door with DG700 manometer
Minneapolis duct blaster with DG700 manometer
Carbon Monoxide Meters BACHARACH III
Combustible Gas Leak Detectors BACHARACH
I need to buy everything in the next 2 weeks. You can reach me at alfredo@e3-elements.com

Views: 100

Comment

You need to be a member of Home Energy Pros Forum to add comments!

Join Home Energy Pros Forum

Comment by Matt Danielson on December 31, 2013 at 12:56am
Hello Alfredo,
I have a Mpls Duct Blaster, dG700 manometer, bag, duct pans, rolls of adhesive film, all with practically no usage. Our ducts in Mpls area tend to be within the envelope and as a result this equipment has seen little use. My email is matt at greenhomedr.com. Thanks

Forum Discussions

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by Bill Spikowski 3 minutes ago. 26 Replies

Psychrometric Chart Training

Started by John Krochmalny in Training. Last reply by Mahendra Shah on Friday. 1 Reply

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco Oct 16. 1 Reply

Latest Activity

Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"As to the elevations on the cupola – the existing windows up there might survive adding…"
5 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"The purlins are 1 3/4" thick. I believe the top chord of the trusses are 10" deep (but…"
6 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"The cupola windows are the only place there would be a problem if 4" of foam were added above…"
8 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"The purlins are 1 3/4" thick. I don’t know about the fire dangers of PIC or other foams.…"
9 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"Exposed rubber washers would disappear in a hurry! I used a screw assembly with a stainless cup…"
10 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"The existing metal roof probably overhangs the outer edge of the lowest purlin about an inch, maybe…"
15 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"It shouldn’t be that hard to fasten thin foam panels between the existing ribs, but if I put…"
16 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"This is Bill Spikowski – David Butler has been helping me figure out how to make my getaway…"
18 minutes ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service