So are you curious about what is going to be covered in this class for Raters? This blog post was pulled from my original article done back in February. This class was taught by Allison A Bailes III of Energy Vanguard, and was tweeted live with the hash tag – #ES3. As a quick FYI, this was one of a few classes that was given a waiver to be taught earlier, as it was already scheduled before they changed their rollout & training dates. (In case you are looking for day 1 - it can also be found here on HEP's)


As a quick note - these were my thoughts at the time, and some issues noted here have been addressed already. I still do see some issues with some of the items listed below, and a few that have come to light recently - but all in all it is a good program & we have at least until January to see what the program will really look like.


The Last Day:

Well today was the last day for the mandatory class, where we finally went through the final three checklists. We started the day off with a RemRate file & simply told to get it into compliance with the new version of ENERGY STAR. As a quick tip for any fellow raters, do not forget about the new screen that follows the Lights & Appliances section & check all the applicable boxes. You can then simply run / utilize the ES V2.5 Home & Summary Reports. They will show you which items need to be addressed to help you get the house up to snuff, like the insulation quality, blower door & duct leakage numbers.


While going through this practice exercise, we did notice a few issues with the software QC. The first one is that it will pass you, even if you do not have enough insulation per the standards. The second major issue, was that while upgrading a few items (roof, furnace, etc…) was that the HERS number actually went up, instead of down. I expect those issues will be addressed shortly, but until then just be forewarned. (Version 12.91)

Water Management Checklist:

Instead of following the class format exactly, I am going to skip ahead & cover the Water Management Checklist first. This checklist is for the builder to verify, and address issues related to keeping water out of the structure. Some of those items revolve around proper drainage, plastic under the slabs, flashing details, etc… With that said, some newer builders, or even the building owner may wish to have an experienced rater verify certain items during the installation period & help train certain sub-contractors or builders on exactly what XY or Z means.

The builder or homeowner may even decide to opt out of this checklist all together if they decide to go for a double certification – namely ES & the Indoor airPLUS program. While you can pursue the ES program without the airPLUS, you cannot pursue the airPLUS program without the ES one. One item I did find interesting and may push some over to the airPLUS program, is that there is no mention of utilizing radon preventative measures in the ES program.

One last quick note – maybe it is just me, but I always have to seemingly look up what class a vapor retarders falls under:

  • Class 1 Vapor Retarder – has a perm rating of less than .1 perm
  • Class 2 Vapor Retarder – has a perm rating between .1 to 1 perm
  • Class 3 Vapor Retarder – has a perm rating between 1 to 10 perms

Uh, uh oh (HVAC checklists):

First off, there are two checklists that revolve around the HVAC section; one that is compiled by the designer / installer and one that is to be completed by the rater. While joking about it, I sent out the following tweet; I have a sneaky feeling that the person that wrote the RRP regulation wrote this HVAC checklist & they must have been drunk at the time…  Well, low and behold, we were handed an older draft checklist to utilize that has since been corrected. Oops

As I mentioned in yesterdays article, the consensus from those that taught the trainers, is that the program will lose approximately 50% of its builder base when this program is fully rolled out. After looking at, and going through this whole thing, I wonder if they are simply hoping to hold onto 50% of their base. While the two checklists we reviewed were not to onerous at all, they have really kicked it up a few notches on the HVAC system.

In all sincerity, a lot of this stuff would be nice if done, but for the most part this is complete overkill for 90% of the houses built today and in many cases redundant. The one nice part about this class was at the end we were asked – how can we make this program work / what changes should be made / how can we sell the program? While most of it was a rehash over how to fix the HVAC portion, it was a good exercise on also looking at the good points.

With that in mind, let us look at how we can make it better & fix it. First, the two checklists are a good idea. The installation contractors / design checklist, well that I will leave that to someone more knowledgeable. While balance testing and other items would be nice, I think many of us would be happy if they actually did the manual J’s & D’s properly & didn’t just slap the units in. With this in mind, this brings up the issues with the raters checklist that needs a major overhaul.

  • Instead of looking up nebulous items, let’s look at what the most common problem areas are make sure they are correct. (i.e. there is nothing that says that the checklist has to utilize all the white space on the paper)
    • Is the SF size & area listed on the design checklist correctly & does it match the Manual J (we have that already in our rating file)
    • Is the number of occupants, the design temps, leakage rates, insulation, windows, etc… correct?
  • Are the design sheets completed, and were all the appropriate manuals (J, S, T, & D) / certificates printed out and provided?
  • Does the duct sizes & insulation match up with the provided diagram / specs and installed properly?
  • List the duct leakage testing numbers – is it better than X? (We need this information already for our final rating, if we are doing a Performance Path based house)
  • As for all the testing for balance, flow, etc… (Sections 5 – 11) that should already be completed by the ES Qualified HVAC contractor / is already addressed in the diagrams &/or by local code inspections.
  • Section 10 – are you kidding, you want a fully balanced system, require mechanical ventilation in every house, and then you turn around and allow an atmospherically vented piece of equipment in the structure which uses conditioned air? Sorry but that needs to go as it has no place in a modern home.

Misc. Notes:

As we were addressing the “how to make this work,” I would have to side with RESNET and many others, and state that the transition period should be completed over a one year period. I also think with some more feedback from the numerous stakeholders involved & impacted by this, the program will definetly change, and be a lot better when it rolls out. This should help minimize any losses, while still resulting in homes being certified that are 15 to 20% better than the current batch of ES homes.

Views: 100

Tags: #ES3, ENERGY, STAR, V3


You need to be a member of Home Energy Pros Forum to add comments!

Join Home Energy Pros Forum

Latest Activity

Dannie Jackson liked Allison A. Bailes III's group HVAC
1 hour ago
Dannie Jackson added a discussion to the group Energy Efficient Design
2 hours ago
Dannie Jackson liked Barry NewDelman's discussion Help your Clients save, THEN do what you do best
2 hours ago
Dannie Jackson replied to Barry NewDelman's discussion Whats the Consensus of this group Define "Energy Efficiency" in the group Energy Efficient Design
"Design wise I would say that energy efficiency is defined by the Btu / square foot.  This is…"
2 hours ago
Dannie Jackson joined Chris Laumer-Giddens's group

Energy Efficient Design

Energy efficiency starts at the drafting table...How architects and designers can help buildings…See More
2 hours ago
Dannie Jackson liked Chris Laumer-Giddens's group Energy Efficient Design
3 hours ago
Dannie Jackson posted a blog post
4 hours ago
Dannie Jackson liked Home Performance Coalition's blog post Building a Market for High-Performing Homes
5 hours ago


  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service