Mark Furst
  • Fort Atkinson, WI
  • United States
Share on Facebook Share
  • Blogs
  • Discussions (14)
  • Events
  • Groups
  • Photos
  • Photo Albums
  • Videos

Mark Furst's Discussions

Bath fan weirdness

Started this discussion. Last reply by Bruce Fillmore Oct 11, 2018. 13 Replies

I recently measured disappointing bath fan flows at a project - both being below our program minimum of 50cfm. The builder had the installer come back to have a look and found nothing obvious but he…Continue

Worst boiler ever?

Started this discussion. Last reply by Mick Lane Mar 15, 2018. 1 Reply

It's the little things…Continue

Tax Credit and the LTO test

Started this discussion. Last reply by Mark Furst Mar 10, 2018. 4 Replies

Anybody else super frustrated by the retroactive implementation of the tax credit?I have 2 big problems with this:1)Most all of the homes I rated last year did not pass the tax credit because I opted…Continue

Tags: test, LTO, Credit, Tax

 

Mark Furst's Page

Latest Activity

Bruce Fillmore replied to Mark Furst's discussion Bath fan weirdness
"In my opinion venting into any soffit is a bad idea, it usually requires a sharp bend to get into the soffit, and reduces insulation value where it crosses the top plate. (significantly)  Better going through the sidewall or box/gable, nice…"
Oct 11, 2018
Tray Biasiolli replied to Mark Furst's discussion Bath fan weirdness
"I'd agree with Sean - we get wind effects regularly when measuring ventilation fan intake at the outdoor hood. And there's a notable difference if the capture hood is flush with the wall (eg around foundation wall) or if there are gaps,…"
Oct 11, 2018
Charles Buell replied to Mark Furst's discussion Bath fan weirdness
"You would have to test the vent at the inside at a location the same diameter as the outside diameter to get the same CFM reading."
Oct 11, 2018
Sam Karpowicz replied to Mark Furst's discussion Bath fan weirdness
"What size is the exhaust vent?  I helped with a project in the past where the exhaust was vented out with 3-4" vent (forget which one).  But it wasn't reaching its stated exhaust flow rate.  The contractor had to come back…"
Oct 9, 2018
Sean Lintow Sr replied to Mark Furst's discussion Bath fan weirdness
"I will go back to how did you seal up tight / anything else that could impact the flows (just remember that those nice arrows we draw for flows... well nature has a way of screwing with you - especially with wind)"
Oct 5, 2018
Mark Furst replied to Randall Olsen's discussion How to measure room pressures
"Busy days "I have never seen an inside wall that did not leak to the exterior." I have noticed some top plate leakage at a handful of walls in some homes but certainly not enough to make a blanket statement about "all" walls. I…"
Oct 5, 2018
Mark Furst replied to Mark Furst's discussion Bath fan weirdness
"I use an Alnor flow hood which I know works both inside and out as I recently measured flows for an ERV installation. "
Oct 5, 2018
Brad Cook replied to Mark Furst's discussion Bath fan weirdness
"Maybe it is because at the fan, you are measuring negative pressure and at the soffit it is positive pressure. I am guessing that you are using the Energy Conservatory fan flow hood. Check with TEC about that."
Oct 4, 2018
Kent Browning replied to Mark Furst's discussion Bath fan weirdness
"Depends on the insulation. Batt insulation I would not expect much to be drawn in. Cellulose insulation would likely restrict the leakage to where my theory does not work. Blown in fiberglass could draw in some insulation but it might be a very…"
Oct 2, 2018
Sean Lintow Sr replied to Mark Furst's discussion Bath fan weirdness
"Was it at all windy - just how did you test / equipment? How did you seal tight on the exterior? I have seen interesting results on ERV's intake, exhausts, etc..."
Oct 1, 2018
Mark Furst replied to Randall Olsen's discussion How to measure room pressures
"Leakage, yes, but to where? The interior? These are only run in interior walls (exteriors have to be ducted) and, generally they work just fine unless they have the installation problems I mentioned above. Plus, the contractors are much getting…"
Oct 1, 2018
Mark Furst replied to Mark Furst's discussion Bath fan weirdness
"Yes, I should have stated: 6' straight run, all insulated flex insulated duct with tightish bends down to the soffit terminations which did yield a tad more cfm when we pushed up to relax the curve. But my confusion is how does it end up being…"
Oct 1, 2018
Mark Furst replied to Mark Furst's discussion Bath fan weirdness
"Reasonable theory, but if that was the case I'd expect to see some insulation (in which the fan is buried) drawn along with that airflow, no?"
Oct 1, 2018
Sean Lintow Sr replied to Mark Furst's discussion Bath fan weirdness
"Just to add on to common problems... Short - as in straight, pulled tight with minor bends (assuming flex)? Just what is short - 10', 20'? Most issues I see besides birds nest is hard bends, full 25' worth of material going only…"
Oct 1, 2018
Kent Browning replied to Mark Furst's discussion Bath fan weirdness
"I am guessing based on what you posted. I suspect the fan collar to exhaust duct is leaking. If my guess is correct, the fan is acting like an "ejector pump". as the airflow passes the leaking collar it pulls in more air thru the leak.…"
Oct 1, 2018
Mark Furst posted a discussion

Bath fan weirdness

I recently measured disappointing bath fan flows at a project - both being below our program minimum of 50cfm. The builder had the installer come back to have a look and found nothing obvious but he did get a couple of new fan motors and swapped them out and also double checked that the damper flap wasn't stuck. There was a slight improvement to both but it was not enough, still both below 50.These fans were routed - with a short run of duct - to soffit terminations which allowed us to look up…See More
Oct 1, 2018

Profile Information

Company
Grading Spaces LLC
Role in Home Performance Marketplace
Energy auditor / assessor / analyst
Professional Certification
BPI, HERS Rater, Home Energy Score Qualified Assessor, RESNET
Website URL
http://www.gradingspaces.com

Comment Wall (1 comment)

You need to be a member of Home Energy Pros Forum to add comments!

Join Home Energy Pros Forum

At 5:34pm on March 12, 2018, Diane Chojnowski said…

Hi Mark,

Welcome to Home Energy Pros Forum. Feel free to join the conversation in the Forum and Groups. And share your energy efficiency photos, videos, and upcoming events. If you're blogging about home performance, this is the place for you!

Thanks!

Diane, HEP Forum Moderator

 
 
 

Forum Discussions

New(ish) ZNE publications available

Started by Ann Edminster in General Forum. Last reply by Jacob Corvidae 7 hours ago. 1 Reply

Energy OutWest 2020

Started by Diane Deyerler in General Forum 9 hours ago. 0 Replies

Proper means of insulating raised floor above concrete

Started by Matthew Greenawalt in General Forum. Last reply by Franco Oyuela on Tuesday. 6 Replies

The Nest Learning Thermostat - Good or Not So Much?

Started by Melissa Baldridge in General Forum. Last reply by Franco Oyuela on Monday. 67 Replies

Latest Activity

Coby Rudolph commented on Jim Gunshinan's blog post What Are the Nation's Best Utility Energy Efficiency Programs?
"Interesting. Something needs to change when 30% of the exemplary programs (16 out of 53) saw…"
5 hours ago
Dimitri Mal joined Bob Krell's group
Thumbnail

Healthy Indoors (IAQ)

The Healthy Indoors group is focused on indoor air quality (IAQ), mold, moisture control, radon,…See More
6 hours ago
Dimitri Mal joined allen p tanner's group
Thumbnail

Energy Auditing Equipment for Sale, Trade or to Purchase

Discuss the pros and cons of the equipment you are interested in prior to purchase. Post equipment…See More
6 hours ago
Jacob Corvidae replied to Ann Edminster's discussion New(ish) ZNE publications available
"Great to see these Ann. Thanks for sharing. "
7 hours ago
Jacob Corvidae commented on Pearl Certification's blog post New Study Measures Impact of Energy Efficient Features On Home Sale Prices in Phoenix
"Congrats folks - great to see that moving forward. We'll look forward to the…"
7 hours ago
tedkidd commented on Jim Gunshinan's blog post What Are the Nation's Best Utility Energy Efficiency Programs?
"Midwest energy is the only program I've run across that's worth a damn. VT and Austin…"
7 hours ago
Jan Green commented on Pearl Certification's blog post New Study Measures Impact of Energy Efficient Features On Home Sale Prices in Phoenix
"The link to the study doesn't work. "
8 hours ago
Jan Green commented on Pearl Certification's blog post New Study Measures Impact of Energy Efficient Features On Home Sale Prices in Phoenix
"Excellent forward thinking partnership.  Gaining momentum with this partnership is HUGE!…"
8 hours ago

© 2019   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service