VISTA AC

Single AC unit serving 2-story 1,200 sq ft paint store show room. Done on a 103 degree day. Immediately dropped interior air temp 7 degrees. Next day, also 103 degrees. Manager called and said it was 12 degrees colder than before the RCC was applied to the AC unit.

Views: 59

Comment

You need to be a member of Home Energy Pros Forum to add comments!

Join Home Energy Pros Forum

Comment by Hal Skinner on August 7, 2014 at 11:41pm

In most cases, water and a brush.  If the surface area is filthy, oily, greasey, what works best is liquid tide with bleach.  We will wet down the surface area, AC unit, metal roof etc, spray on liquid tide with bleach from a garden sprayer, scrub it, rinse it, let it dry.   100% environmentally friendly.  Once dry, spot prime any rust.  Spray or roller on the RCC.  Cooling effect is immediate.

Comment by Eric Kjelshus on August 7, 2014 at 9:35pm

what do you clean it with?  Most RTU are just nasty - grease from Kitchen to concrete  dust to road tar to bird dropping 

Comment by Hal Skinner on August 7, 2014 at 6:20pm

Our RCC is such a good sealant it is used as an encapsulant material for asbestos.  But, that had no bearing on this application.

 

I apologize for lack of good editing on here.  My vision is bad enough it is very difficult.

Comment by Hal Skinner on August 7, 2014 at 5:43pm

Hi Eric,

I did this one myself.  I cleaned it, masked off all the ID plates and stickers and painted on our RCC.  Nobody did anything with the outside air intake.

Our RCC has Solar Reflectivity of 0.83

                                 Emissivity of  0.90

Here is how that was explained to me by a couple of folks from energy labratories.

Using our numbers;  83% of the sun's heat energy is reflected away from the material.

This leaves 17% that actually enters the surface of the material.

Of THAT 17%, 90% of that is emitted back into the atmosphere.

Do the math and that leaves 1.7% that actually goes past  the RCC and enters the building.

 

If your numbers are referring to ther 'coloor spectrum, I will give an example of a white RCC does vs standard white paint.

@00,000+ sq ft metal building.  Egg processing pl;ant in Texas.  Metal roof was white from the factory (Baked enamel?)  Walls were a light yellowish tan from the factory.

First thing cpoated was the roof..  That immediately dropped the surface temperature from 196 degrees down

to 110 degrees.  It also dropped the attic air teperature by 60 degrees.  Iy was a 108 degree day.

The surface temperature of our RCC will alway be within 5 degrees of whatever the ambient air teperature is at that moment..

IT AINT PAINT!  :)

 

Comment by Eric Kjelshus on August 7, 2014 at 3:59pm

I have seen roof top units leak 45% on both supply and return.   I have see the slitter between supply and return just rot with leaking air- conditioned air hits hot air than rains.   Yours is more just color than sealing, black is 93% and white is 7% solar heat pick up.  How much of that is from closing the outside air off?

Forum Discussions

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler 1 hour ago. 34 Replies

Psychrometric Chart Training

Started by John Krochmalny in Training. Last reply by Mahendra Shah on Friday. 1 Reply

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco Oct 16. 1 Reply

Latest Activity

David Butler replied to David Butler's discussion How would you insulate this roof?
"Sean Lintow proposed rails and clips (re: first comment in this discussion), but in the context of…"
1 hour ago
Brad Cook replied to David Butler's discussion How would you insulate this roof?
"I missed where the suggestion for rails came in. The plywood would not need any rails. 4+ inches is…"
5 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"I'm a little confused about the necessity and purpose of using support rails if working on…"
6 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"If you insulate master bedroom and family room from below, you definitely need more R-value than…"
6 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"Brad, I was only talking about using EPS between the ridges, if necessary, to conform to bolts.…"
6 hours ago
Brad Cook replied to David Butler's discussion How would you insulate this roof?
"It kind of depends on the PIC. Not all insulation is made the same. Here in VT (and all of New…"
6 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"Filling those shallow valleys with rigid foam not only prevents primary foam panels from…"
6 hours ago
Brad Cook replied to David Butler's discussion How would you insulate this roof?
"Bill, you just posted a number of responses in different areas of the thread. I will try to respond…"
11 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service