Foundation Thermal Sketch

This is here to point out the total lack of recognition of heat-transfer, we just patch up the problem with some insulation here, some vapor barrier there.

Views: 88

Comment

You need to be a member of Home Energy Pros Forum to add comments!

Join Home Energy Pros Forum

Comment by Tom Mallard on March 28, 2011 at 11:02am

The foundation is hard to control for heat-transfer due the compression loads, can't say I've solved anything other than to ponder insulation that can handle the loads to replace the board joists are usually nailed that's anchored to the concrete. That would be a worthy new product for energy conservation in home construction.

Another I've thought of tho' is where joists are open to the interior floor, that first foot needs to breathe but my opinion needs to be stuffed with insulation with the paper torn off to allow breathing of condensation but killing direct air movement.

That area is like a chiller in winter, the cold air from the wood gets warmed enough right there to rise and creep along the floor above the typical insulation just from sag between it and the wood!!

Comment by Tom Mallard on March 28, 2011 at 9:03am
Too true ... I'm such a misfit ...
Comment by Jim Peck on March 28, 2011 at 6:50am
As specie whom claims such intelligence, we do seem remarkably shortsighted

Latest Activity

Dara Bowser replied to Don Fugler's discussion joining ducts in the group HVAC
"Good to hear you have clean dryer ducts Don. The dryer duct issues that we run into are…"
3 hours ago
Don Fugler replied to Don Fugler's discussion joining ducts in the group HVAC
"David, If the IMC mandates metal dryer duct and prohibits metal screws, they must be accepting…"
5 hours ago
David Butler replied to Don Fugler's discussion joining ducts in the group HVAC
"I never checked that before. Checking now... Section M1502.4.2 of the International Residential…"
5 hours ago
Joseph Frasier is now a member of Home Energy Pros Forum
5 hours ago
Don Fugler replied to Don Fugler's discussion joining ducts in the group HVAC
"Brendan, Thanks for that response. Because of your warning, I just went down to the basement and…"
9 hours ago
Brendan Reid replied to Don Fugler's discussion joining ducts in the group HVAC
"Hi Don, Summary: DRYER VENT: screws bad idea, possibly prohibited by code. METAL DUCT: must be…"
9 hours ago
Profile IconBrendan Reid and David Butler joined Allison A. Bailes III's group
Thumbnail

HVAC

HVAC design, Manuals J, S, T, & D, Duct leakage, Air flow, ENERGY STAR new home requirements,…See More
9 hours ago
Profile IconSean Wiens and David Butler joined Chris Laumer-Giddens's group
Thumbnail

Energy Efficient Design

Energy efficiency starts at the drafting table...How architects and designers can help buildings…See More
17 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service