Greetings everyone,

   I have a strange scenario to model and I was hoping I could get some advice: This used to be a whole building built on 1,920 so it is a balloon framing. The homeowner' s apartment is on the second floor, but the front door on the first floor has a little area with a little "receiving" table and that area is heated with a radiator. The basement ceiling has no insulation at all and because of the framing style, it brings a great deal of air into the 2 floor (proved by the blower door) 

   The entire house is two floors plus attic, but I am modeling a little piece of the first floor, second floor, attic and basement... Any suggestions on how to do this?

  Your comments are greatly appreciated,

                              Luis

Views: 152

Replies to This Discussion

Paul, Good Evening, John here, did you ever get an answer from anyone to this question?  I am fairly new to TREAT but I am willing to discuss this if it still matters to you?

John@jwlasso.co.uk

Boy, Luis, sorry to see this so late.

Curious what you did.  Our general approach would be to model only the surfaces in the apartment  that are adjacent to unconditioned space, so leaving off floors and walls that are adjacent to the neighboring apartments.

What approach did you use?

Ethan 

RSS

Discussion Forum

Basic Heat loss information

Started by Luis Hernandez. Last reply by tedkidd Oct 30, 2014. 1 Reply

How to model a skylight

Started by Luis Hernandez. Last reply by Luis Hernandez Oct 16, 2014. 2 Replies

Modeling the apartment upstairs

Started by Luis Hernandez. Last reply by Ethan MacCormick Sep 26, 2014. 2 Replies

Modeling a Townhouse

Started by Luis Hernandez. Last reply by Luis Hernandez Jul 7, 2013. 4 Replies

Latest Activity

Dara Bowser replied to Don Fugler's discussion joining ducts in the group HVAC
"Good to hear you have clean dryer ducts Don. The dryer duct issues that we run into are…"
8 hours ago
Don Fugler replied to Don Fugler's discussion joining ducts in the group HVAC
"David, If the IMC mandates metal dryer duct and prohibits metal screws, they must be accepting…"
9 hours ago
David Butler replied to Don Fugler's discussion joining ducts in the group HVAC
"I never checked that before. Checking now... Section M1502.4.2 of the International Residential…"
9 hours ago
Joseph Frasier is now a member of Home Energy Pros Forum
9 hours ago
Don Fugler replied to Don Fugler's discussion joining ducts in the group HVAC
"Brendan, Thanks for that response. Because of your warning, I just went down to the basement and…"
13 hours ago
Brendan Reid replied to Don Fugler's discussion joining ducts in the group HVAC
"Hi Don, Summary: DRYER VENT: screws bad idea, possibly prohibited by code. METAL DUCT: must be…"
13 hours ago
Profile IconBrendan Reid and David Butler joined Allison A. Bailes III's group
Thumbnail

HVAC

HVAC design, Manuals J, S, T, & D, Duct leakage, Air flow, ENERGY STAR new home requirements,…See More
13 hours ago
Profile IconSean Wiens and David Butler joined Chris Laumer-Giddens's group
Thumbnail

Energy Efficient Design

Energy efficiency starts at the drafting table...How architects and designers can help buildings…See More
22 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service