We are planning an energy audit in southern Wisconsin on a mid-rise building where every apartment has a self-contained Anderson "Magic Pak" HVAC unit. These are a combo NG furnace/package AC ducted forced air system, set into a three foot by four foot grille in an exterior wall for condenser cooling and furnace exhaust.

Since these buildings are in a heating-dominant climate, getting good SSE readings on the existing units is important to me. The furnace exhaust ports out a short tube through the grille directly to outdoors. I think we can test the first floor units from outdoors -- the results seem to vary a little depending on just where the combustion probe in in the exhaust stream.

Does anyone know how we could test second-floor (and higher) units without humping a ladder all the way around the building?? Anyone have literature or experience drilling into the exhaust stream somewhere from the building side of the unit?

Views: 299

Replies to This Discussion

second-floor (and higher) units without humping a ladder all the way around the building is a very complicated task and i think cant be possible here

Thanks
website

Yes,

Get a bucket truck!

RSS

Discussion Forum

Testing "Magic Pak" units??

Started by Don Hynek. Last reply by Rich Manning Jun 2, 2016. 2 Replies

Blower Door Applications Guide

Started by Kim Tanner. Last reply by Colin Genge Aug 3, 2015. 1 Reply

Job opening: Multifamily Services Manager

Started by Jonathan Beers Mar 16, 2015. 0 Replies

Latest Activity

John Krochmalny posted a discussion

Psychrometric Chart Training

Looking through the various areas of this site, I didn't see too much information or training on…See More
1 hour ago
Profile IconMike Malek, Avery T. Phillips and Sarah Burger joined Home Energy Pros Forum
2 hours ago
Dannie Jackson's blog post was featured

Core Heat And Other Concepts

  In some places the use of solar heated liquids from hot water solar panels are used to provide…See More
6 hours ago
Michael Duclos replied to Brad Cook's discussion Too many Heat Pump Water Heaters in a basement?
"I’ve been looking into Sanden for a multi-family PH near Laconia, NH, ASHRAE 99.6% temp is…"
6 hours ago
Profile IconTroy Spindler, Mike Berg, Andrew McDowell and 4 more joined Home Energy Pros Forum
yesterday
David Butler replied to Brad Cook's discussion Too many Heat Pump Water Heaters in a basement?
"theoretically, let's say you perfectly isolate the HPWH from a heat source. The HPWH's…"
yesterday
David Butler replied to David Butler's discussion How would you insulate this roof?
"Interesting idea. Commercial roof on a slope! Typical density for roofing spray foam is 2.5 to 3.0…"
Monday
Summer Redman added a discussion to the group Job Board
Thumbnail

Hiring 2 Training Specialists in Champaign-Urbana, Illinois

The Applied Research Institute (ARI) at the University of Illinois at Urbana-Champaign is seeking…See More
Monday

Photos

Loading…
  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service