Dennis Heidner's Discussions (203)

Discussions Replied To (13) Replies Latest Activity

"The white stuff -- is probably combustion by products.  And I might be expected.  Yo…"

Dennis Heidner replied Jan 18, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"If the pipe was galvanized... zinc will oxide with a "white rust"  not really deadly…"

Dennis Heidner replied Jan 14, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"Cool... a success story... without the fireworks..."

Dennis Heidner replied Jan 14, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"Anthony, Those are good comments!   I've seen the same... and I've walked into new…"

Dennis Heidner replied Jan 11, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"I'm pretty sure code would also require separate outlet for the WH... it should not…"

Dennis Heidner replied Jan 6, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"It should probably have had two straps for seismic hold down... and gas line looks l…"

Dennis Heidner replied Jan 5, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"I've done the tankless with chillipepper on-demand pump, wireless controls, light sw…"

Dennis Heidner replied Jun 13, 2013 to Thank-less water heater

12 Jun 13, 2013
Reply by Dennis Heidner

"Complete with creative venting... but no worries  its outside. PTV has been routed…"

Dennis Heidner replied Mar 23, 2013 to water heater installation in San Francisco Ca. O yes and an outside stacked washer and dryer on the 2nd story back porch!

3 Mar 25, 2013
Reply by Bill Smith

"Condensing right?    They must not have heard of stainless steel flexible vent pipes…"

Dennis Heidner replied Mar 23, 2013 to Found a part that fits.

3 Mar 23, 2013
Reply by Dennis Heidner

"This is a heat pump hot water heater right?! Looks like ther is a cord on the left.…"

Dennis Heidner replied Mar 22, 2013 to Found a part that fits.

3 Mar 23, 2013
Reply by Dennis Heidner

RSS

Discussion Forum

Got insulation?

Started by Debra Little. Last reply by Jason Raddenbach May 25. 2 Replies

Return Possum

Started by Stefan Peter-Contesse. Last reply by Alice La Pierre Oct 26, 2015. 1 Reply

Easy Water Heater Venting

Started by Kari Sauder. Last reply by Matthew Lutz Oct 23, 2014. 22 Replies

Thank-less water heater

Started by Andy Simms. Last reply by Dennis Heidner Jun 13, 2013. 12 Replies

Latest Activity

Profile IconAlice Quinn and Donald Hester joined Home Energy Pros Forum
27 seconds ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"In an earlier response, I noted that we COULD haul drinking water and use the water we collect off…"
20 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"As to the elevations on the cupola – the existing windows up there might survive adding…"
21 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"The purlins are 1 3/4" thick. I believe the top chord of the trusses are 10" deep (but…"
23 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"The cupola windows are the only place there would be a problem if 4" of foam were added above…"
25 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"The purlins are 1 3/4" thick. I don’t know about the fire dangers of PIC or other foams.…"
26 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"Exposed rubber washers would disappear in a hurry! I used a screw assembly with a stainless cup…"
27 minutes ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"The existing metal roof probably overhangs the outer edge of the lowest purlin about an inch, maybe…"
32 minutes ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service