This discussion forum is to attempt to answer Steve's question regarding better ways to model domestic hot water systems.  Here is his question.

 

"Things appear rather quiet over here in Building Simulations, so I thought I might stir up some discussion on the subject of DHW storage temps, as they apply to dishwasher usage. Cruise on over to "Top-10 just launched" on the home page under Forums and go down to "comments" where J.C. and I went somewhat off topic with a discussion of DHW temps. I'm reasonably sure simulations would support maintaining DHW @ 115-120 F, and using electric heat in the DW to boost the temp as the most energy efficient approach, but have found no difinitive study. I suspect this issue has been settled, but would appreciate your thoughts and the results of any simulations you may have run or encountered. "

Views: 92

Replies to This Discussion

Perhaps time to put this situation aside and move on. While I never did locate a rigorous study, the sheer volume of information advocating booster electric heat in the dishwasher vs maintaining a higher DHW storage temp would seem to support the former as the preferred approach. I believe Energy Star DW's use less than 10 gallons of dihydrogen monoxide and the delta T should be on the order of 20-25 degrees, so probably no big deal...unless your fuel source is dollar bills.

Still, would have liked to see results from running a "what if" program...

RSS

Discussion Forum

Transient Heat Transfer Analysis

Started by James White. Last reply by James White Dec 10, 2013. 5 Replies

How about simulation in the multifamily context?

Started by Evan Mills. Last reply by Don Hynek Jan 23, 2012. 6 Replies

Modeling Domestic Hot Water Systems

Started by James White. Last reply by Steve Waclo Nov 24, 2010. 1 Reply

Latest Activity

Profile IconSean Wiens and David Butler joined Chris Laumer-Giddens's group
Thumbnail

Energy Efficient Design

Energy efficiency starts at the drafting table...How architects and designers can help buildings…See More
6 hours ago
Profile IconSean Wiens and David Butler joined Mark Richardson's group
Thumbnail

Renewable Energy

This group will focus on the issues associated with incorporating renewable energy sources like…See More
6 hours ago
Al Tibbs posted photos
7 hours ago
Al Tibbs replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"In any case where there is visible mold present, I would begin with a thorough VISUAL assessment of…"
7 hours ago
Al Tibbs joined Bob Krell's group
Thumbnail

Healthy Indoors (IAQ)

The Healthy Indoors group is focused on indoor air quality (IAQ), mold, moisture control, radon,…See More
7 hours ago
David Byrnes posted a blog post

Strategies for Hiring and Interviewing for Home Performance Professionals

Hire slow and fire fast.  It’s a phrase that experienced managers and human resources professionals…See More
8 hours ago
David Butler posted discussions
8 hours ago
David Butler replied to Don Fugler's discussion joining ducts in the group HVAC
"Static pressure drop through a straight length of pipe is a function of friction rate, and friction…"
13 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service