The L-shaped probe grew legs, so this was improvised with a straight metal tube. There seems to be a persistent notion that angling the probe toward the appliance (into the exhaust stream) is the correct technique, but wouldn't this result in interference from ram air pressure of the rising flue gases?

Tags: CAS, CAZ, analysis, combustion, draft, pitot, safety, spillage, tube

Views: 850

Reply to This

Replies to This Discussion

Ted, I see your point now. Thanks for clarifying. The CAZ pressure was recorded independly of the draft. I haven't seen anyone measure both results simultaneously on one manometer, but that is a really good way to illustrate the interaction between the two forces.
... and one of the things that makes dg700 such a cool tool.

When testing draft, using the straight probe will be a close approximation of static pressure because the velocity is so low.  You should have the end of the probe close to the center of the vent and at a 90 degree angle to the pipe. 

Forget the draft measurement issue,,, just look at that incorrectly applied pipe wrap next to the flue.. Surprised it hasn't melted yet. Anyway,,, many who follow the 1200 standard simply test draft using a smoke pen or some visible indication (yes a mirror does work) of proper draft. The old BPI rule of outside temp and draft pressure failure made no sense at all when we could visibly see it drafting under worst case conditions.. 

I agree that checking for combustion spillage is more important that checking for draft.  It is possible to have high draft pressures and spillage at the same time.  For example, if a 75,000 BTU water heater is vented with a 3" pipe, you will have high draft pressure and spillage at the same time.

RSS

Forum Discussions

VERY TIGHT HOME WITH OVER SIZED AC

Started by Jerry Needham in BPI. Last reply by Dave Taylor yesterday. 6 Replies

Mini split air conditioners and ceiling fans

Started by Beverly Lerch in General Forum. Last reply by Daniel Baur-McGuire on Monday. 4 Replies

DIY Filter Solution for an Evaporative Cooler, anyone?

Started by Leslie Jackson in HVAC. Last reply by Daniel Baur-McGuire on Monday. 6 Replies

Apply now for the Jon Siemen Memorial Scholarship!

Started by Diane Chojnowski in General Forum. Last reply by Quinn Korzeniecki Aug 9. 1 Reply

Latest Activity

Michael Schettine commented on Michael Schettine's video
Thumbnail

AccuFrame Water Test

"The Like button doesn't work on this site..."
2 hours ago
Franco Oyuela commented on Mike Muras's blog post "Practical Standards to Measure HVAC System Performance" Rob "Doc" Falke 04/17/2006
"It's important to evaluate and inspect a system regularly to make sure it's at optimal…"
8 hours ago
Seventhwave posted an event

HVAC technology enhancements for energy conservation at The Marq

October 4, 2018 from 8:30am to 4pm
Join us to learn how to get the largest energy savings in your commercial buildings. HVAC as a…See More
13 hours ago
Peter Krych replied to Dav Camras's discussion Adding blown insulation to poorly installed batts?
"I agree, it is wasteful to remove and dump old insulation. I still does its job. Air sealing is…"
15 hours ago
Michael Schettine commented on Michael Schettine's video
Thumbnail

AccuFrame Water Test

"With the conversion rate that- air is 800 time LESS dense than water at sea-level…"
16 hours ago
Michael Schettine posted a video

AccuFrame Water Test

In this short video, water is used to visualize air leakage sites that are present in the majority of framed walls in the US. New regulations require better ...
23 hours ago
Sam Feder liked Dav Camras's discussion Adding blown insulation to poorly installed batts?
yesterday
Chris Stratton liked Don Fugler's discussion Choosing a range hood
yesterday
Dave Taylor replied to Jerry Needham's discussion VERY TIGHT HOME WITH OVER SIZED AC
"Jerry, you should look at Buildingscience.com" High Mass Walls" 105 paper for more…"
yesterday
Jill Lindman's 3 events were featured
yesterday
Jill Lindman posted events
yesterday
Diane Chojnowski posted videos
yesterday
Don Fugler replied to Don Fugler's discussion Choosing a range hood in the group Kitchen Ventilation
"Has anyone installed a range hood in an older home with the ducting down to the basement and out…"
yesterday
Profile IconEileen Kraus-Dobratz, VENI MITTAL and Mark A McCrumb joined Home Energy Pros Forum
yesterday
Brian Robinson replied to Dav Camras's discussion Adding blown insulation to poorly installed batts?
"YES, YES, & YES!!! Bat droppings, mouse droppings, dead mice, nuts, seeds, acorns, lack of…"
Wednesday
Matt Peterson posted a blog post

The Importance of keeping Professionally Trained Gas Line Installation Technicians happy and loving their jobs!

Our company is very much a family to us, we strive to bring in and develop great people into great…See More
Wednesday
Profile Iconyanky fogel, Kathleen Krebs, Nicholas Rubenstein and 3 more joined Home Energy Pros Forum
Wednesday
yanky fogel liked Home Energy Magazine's video
Tuesday
Franco Oyuela commented on Shawn Weeks's blog post How Homeowners Can Keep Electricity Costs Down in Summer Months
"Cutting back on air conditioning is also good for the environment because it reduces carbon…"
Tuesday
Seventhwave posted events
Tuesday

Photos

  • Add Photos
  • View All

© 2018   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service