As an energy auditor I occasionally see vermiculite in the gas fireplaces. Does anyone know if any of the vermiculite they use(d) for fireplaces has asbestos fibers and if it's safe to run blower door?

Thank you

Tags: Fireplace, Vermiculite

Views: 9850

Attachments:

Reply to This

Replies to This Discussion

I put a drop on the fire place  more for the soot  and light fibers.   You can get 3000 PPM CP  very quick with open flame with rock wool or vermiculite what flame hits.   I have vacked at whole room with a tear drop shape from the soot with open flame.  That fire place pipe is just 1/2 black pipe sc 40 with holes drilled it then the gas runs though the rock wool and other fibers to make it look like "real".   When I took at class on asbestos its listed as vemiculite as a holder.  

when in doubt pressurize. That may not be a bad idea for fireplaces in general. I was suprised the first time I saw vermiculite in a fireplace. By pressurizing you won't pull any air past the fibers from the gaps around the damper making it safe even if yuou have asbestos contaminated vermiculite.

 

Eric, if I understood you opinion correctly you would not do a blower door test if there is any vermiculite in the house no matter what. 

That brings me to an interesting question - what if the fireplace newer than 1978? I see newer houses, built in the 80s and 90s that that have fireplaces with vermiculite in them . 

I would assume that any vermiculite in use since 1978 should have been tested safe. 

Cory, I fully agree, pressurizing is always safer in case you have any sources of contamination. 

It wasn't until about 1994 that it was discovered that there asbestos was found in the vermiculite in the Libby-Owen Mine in Montana, which was the source for 70% of the vermiculite sold in the US. Vermiculite is now considered a hazardous material, unless it has been installed since 1994 and the source can clearly be documented. Lots of information on this topic on the Web.

You are allowed to pressurize the blower door test, assuming that you will not be disturbing asbestos fibers that could enter the house. If vermiculite is in the walls and attic, there may be little opportunity for notable energy savings, and you would not be able to determine where the leaks are with a pressurized test, so why bother?

I have never seen vermiculite in or around a fireplace here in Vermont. Where are you finding this vermiculite in fireplaces?

If you go to a fireplace show floor like midwest fireplace or troost fireplace,  they have 40+ working fireplaces mostly nat gas some wood some press wood with chains/dampers  The very high end home will have a mix of rock wool and vermiculite that nat gas or lp gas will burn into, right on the 1 lb poly bag says vermiculite expanded and its an add on,  replace each year,  mix for look.  I get 300 PPM CO off the flame and 100 +- in flue on low and high gets to 3000 PPM CO flame and 1000 PPM CO flue.    I have seen the vermiculite turn black soot then white soot if burn is good.  If you do not cover the soot/vermiculite/rock wool mix you will get a tear drop shape to the blower door.   Its sold to make the fire places look kinda like wood burning. 

Thank you very much for your reply, it was very helpful. 

I've seen a number of fireplaces with vermiculite both in NY and Oregon.

Does anyone have any data on asbestos in the house from running a blower door?  From the attic, basement or a fireplace?  

I'd check with the local installers as to when the orig. install was and what product they were using.  Grace, etc. stopped producing / selling ACM vermiculite in the mid. 90's.

http://en.wikipedia.org/wiki/Vermiculite

Best,

I am an asbestos inspector. The last two times I have tested fireplace vermiculite it has tested negative so its not automatically asbestos. Since its loose and not affixed to or installed in the building its not a regulated asbestos building material. Therefore, its ok for non-certified building inspectors to grab a sample and have it tested. Just make sure you read up on proper technique and safety precautions. Inspectors can use www.DIYsampletesting.com for national service or you may be able to find a local lab that doesn't mind dealing with single samples and submittals from uncertified persons.

Our weatherization protocol (based on Wisconsin DHS rules) says there is no reliable sampling protocol for asbestos  in vermiculite. The reason (I am told)  is that the asbestos fibers laid in veins in the original ore, and not dispersed through the mine. So it was probably NOT dispersed evenly throughout the roasted/processed vermiculite. We were told you could grab a sample from one joist cavity and it would be completely clean. A second sample, three joist cavities over, from a different bag of product, could be loaded with fibers.

We just treat all vermiculite as an asbestos hazard --  it's considered "friable" asbestos, so we do only pressurized blower door tests. But I don't know that I or anyone I know in Wisconsin, has ever seen these vermiculite-laden gas log systems. I know I'd hesitate to do any blower door test if there were a pile ov vermiculite sitting right there in the living room! 

In my testing experience I am not finding that much variability between samples for attic insulation. Stratification is a bigger issue in terms of variability between locations in that the asbestos is found in the smaller settled fraction at the bottom. When I do sampling I typically don't find areas that only contain coarse material, suggesting that settling within the bags was not that significant. Certainly there is more homogeniety in fireplace vermiculite as it all came from the same bag. There are some valid questions about the reliability of the results however that is true with a number of other types of suspect asbestos materials (e.g. hard plaster and floor tile). I have found that regulators tend to exaggerate concerns because they don't understand the inherent variability associated with testing methods and expect everything to be perfectly legally and statistically defensible when that level of accuracy and precision is not usually needed for small residential projects to be adequately protective.

If its vermiculite treat it as having asbestos, unless you want to pay someone to test it, and I would not do a blower door until it has been proven.

RSS

Forum Discussions

Efficiency of furnace

Started by Jignesh in General Forum. Last reply by Barbara Smith on Monday. 7 Replies

Best brands for furnace

Started by Jignesh in General Forum. Last reply by Barbara Smith on Monday. 1 Reply

Insulation Blower Recommendations?

Started by Jim Conlon in General Forum. Last reply by Cameron Home Insulation on Monday. 2 Replies

2005 EPAct tax credit

Started by Mandy Leazenby in General Forum. Last reply by Sean Lintow Sr Feb 15. 3 Replies

Latest Activity

Jacob Corvidae replied to Diane Chojnowski's discussion Support Mike Rogers in the group News & Announcements
"Hey Mike! We're all routing for you! Don't hesitate to ask for help.  Jacob"
12 minutes ago
Jacob Corvidae joined Diane Chojnowski's group
Thumbnail

News & Announcements

Share your news and announcements with the community in this group.To post news or an announcement,…See More
12 minutes ago
Diane Chojnowski added a discussion to the group News & Announcements
36 minutes ago
Profile IconJeannette Moore, David Carson, Jesse Smith and 3 more joined Home Energy Pros Forum
1 hour ago
Home Energy Magazine's blog post was featured

How We Turned Our House into a Giant Foam Box, Part I — Wall Insulation By Wen Lee

Chris Stratton and Wen Lee are a husband-and-wife team living in the Los Angeles area who are DIY…See More
17 hours ago
Home Energy Magazine posted a blog post

How We Turned Our House into a Giant Foam Box, Part I — Wall Insulation By Wen Lee

Chris Stratton and Wen Lee are a husband-and-wife team living in the Los Angeles area who are DIY…See More
17 hours ago
Chris Stratton replied to Chris Stratton's discussion Technical question about mini split heat pump line set maximum length
"Hi Chris, Thanks again for your help. Update: the system is now up and running. Chris"
20 hours ago
Home Performance Coalition's blog post was featured

From Philly to DC: Join Us on Capitol Hill

By now you have probably heard – as part of this year’s …See More
yesterday
Diane Chojnowski added a discussion to the group News & Announcements
Thumbnail

Nominate a visionary leader for the Linda Wigington Leadership Award

The Linda Wigington Leadership Award celebrates visionary leaders doing extraordinary work to…See More
yesterday
Home Performance Coalition liked Chris Morin's blog post HVAC: A Fast Growing Career Opportunity
yesterday
Home Performance Coalition liked Diane Chojnowski's blog post Home Performance Coalition Calls on Congress to Support Federal Energy Efficiency Programs
yesterday
Home Performance Coalition liked Home Energy Magazine's blog post Andrew Scatizzi- Stick to the Basics in New Construction
yesterday
Home Performance Coalition posted blog posts
yesterday
Safe-R Insulation commented on Safe-R Insulation's blog post What are the advantages of Cavity Wall Insulation?
"Hi, Cavity wall insulation are more effective and increase wall life. And it will also help to save…"
yesterday
Profile IconMichael R. Johnson and Jerry Phillips joined Home Energy Pros Forum
yesterday
Sara Watson posted a blog post

6 Tips to Pick Out The Best Solar Outdoor Lights

You have a beautiful home in Florida and plan to add a little sparkle to your front garden, patio,…See More
Tuesday
DesignTech liked DesignTech's photo
Tuesday
Anthony Roy is now a member of Home Energy Pros Forum
Monday
Barbara Smith commented on Barbara Smith's video
Monday
Barbara Smith replied to Jignesh's discussion Efficiency of furnace
"Installation and proper sizing is important to getting the best performance out of your furnace.…"
Monday

Photos

  • Add Photos
  • View All

© 2018   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service