Using Two Exhaust Fans with AirCycler g2/FanConnect

A customer of ours recently asked if it was possible to operate two exhaust fans in two different bathrooms with the AirCycler g2 and FanConnect switch, to get double the exhaust ventilation counted toward the ventilation requirements. The answers is yes.


Here's how, using one FanConnect switch to control two fans:

1. By using a standard 3-way switch in the second bath and wiring to the FanConnect switch, the FanConnect can turn on the exhaust fan in the second bath at the same time it turns on the exhaust fan in the first bath. Otherwise, the second exhaust fan will continue to function normally, turning on when a user flips the 3-way switch.


2. Any time the FanConnect switch is turned on, both fans will run and that time as well as the following delay time will be counted as ventilation at the combined rate of both fans.


3. When required, the AirCycler g2 controller will activate both fans at the same time to provide needed supplemental ventilation.

4. When setting the Measured Exhaust Airflow in the g2 setup mode, enter the flow for both exhaust fans.

More information on the operation and installation of both the AirCycler g2 controller and the FanConnect switch can be found here.

Tags: AirCycler, FanConnect, exhaust, g2, ventilation

Views: 497

Reply to This

Forum Discussions

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler yesterday. 15 Replies

Psychrometric Chart Training

Started by John Krochmalny in Training. Last reply by Mahendra Shah yesterday. 1 Reply

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco on Monday. 1 Reply

Latest Activity

tedkidd replied to Bob Blanchette's discussion Tankless Water Heaters... has their time finally come?
"Yeah. Gas water…"
yesterday
Eric Kjelshus replied to Bob Blanchette's discussion Tankless Water Heaters... has their time finally come?
"With super cheap natural gas prices now, still worth going all electric?  Tankless needs a lot…"
yesterday
Stuart Langley liked Chris Clay's photo
yesterday
David Butler replied to David Butler's discussion How would you insulate this roof?
"Stuart, I wasn't considering the copula windows... yes, those would indeed need to be…"
yesterday
Stuart Langley replied to David Butler's discussion How would you insulate this roof?
"Well, @David Butler, you have seen the property more accurately than I have, but my impression of…"
yesterday
David Butler replied to David Butler's discussion How would you insulate this roof?
"@ Stuart,I don't think there's any concern about impact of 4" build-up on elevation…"
yesterday
Stuart Langley replied to David Butler's discussion How would you insulate this roof?
"So this building has a few issues with air leaks and air leaks have so much to do with discomfort…"
yesterday
Stuart Langley replied to David Butler's discussion How would you insulate this roof?
"John Hatfield has the right idea here for a new roof deck. Polyiso boards always need a good stout…"
yesterday

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service