I'm pretty sure I've never seen this stuff before. It's installed in rafters as batts, held in place by cardboard sheets below. Papery consistency, now crumbling. The house is ~1923, but no idea when this was installed.

Anyone know what it might be? Thanks for any help here.

Views: 6903

Reply to This

Replies to This Discussion

Cellulose?  Where is this house, humid area?

Never saw this, but looks a little like air-cell pipe insulation. This is considered Presumed Asbestos Containing Material.  You should have it tested by an accredited Asbestos Inspector before doing anything to disturb it. 

looks like old rock wool batts

It looks like some insulation I encountered on some ducting installed in the 1960s. I had it tested for asbestos and the results came back as just being all cellulose.

It appears to be mineral wool, but it could also be an old Balsam Wool (wood-fiber) batt. Neither would contain asbestos.

All I can say is that if it isn't known and has the appearance of something that could contain asbestos (i.e., not clearly fiberglass or mineral wool, etc), OSHA requires that it be PRESUMED to contain asbestos and treated as such until negated by testing.  So if unsure, testing is required if its going to be disturbed.

Expanding on the "humid area" question - do you think the material has gone through numerous wet/dry cycles?  Looks like it's turned to dried oatmeal in the pictures

Many thanks to all for suggestions here.

Over at InspectionNews someone else offered the name "Balsam Wool" — and with a little further digging online, that led me to what I now think is the actual answer, an old Kimberly-Clark product called "Kimsul".

Pennsylvania inspector Bill Kibbel, here, describes Kimsul as "layered creped paper," which fits my first impression of the stuff. The photo doesn't convey this very well. And as Ted Kidd says, it's pretty deteriorated at this point.

Kibbel seems certain that Kimsul was manufactured asbestos-free. NY inspector Debra Monte, on the other hand, here seems equally sure of the contrary. So at this point I'm expecting to have to get it tested. — I canned the BD test on my visit date, incidentally, because of this stuff.

I just joined this group, but knew the product immediately from the picture.  Kimsul was installed in all over the City of Richland in the early 1940's.  Richland was a government town built to house workers who were working on the Manhattan project. Were generaly give it an R1 per inch for attics, but in walls it crumbles over time.  I'm very interested in the asbestos testing.  We were told that it didn't have asbestos, I would love to know if you confirmed that.

looks like old rock wool batts

We had a sample of the insulation lab-tested, and the result was a negative without qualification — no asbestos found. This is only one case, of course. For all I know, some of the product was made with asbestos and some wasn't. But it would seem that it's wrong to say definitively that Kimsul has asbestos in it.

Still wise to wear a dust mask in any attic and around insulation generally, of course.

At least you know now.  So many materials contain asbestos its probably more difficult to say it doesn't than it does.  Good luck.

RSS

Forum Discussions

Too many Heat Pump Water Heaters in a basement?

Started by Brad Cook in General Forum. Last reply by David Butler 12 hours ago. 9 Replies

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler 13 hours ago. 2 Replies

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco 19 hours ago. 1 Reply

Fixing a water heater?

Started by John Shillito in Best Practices. Last reply by Eric Kjelshus on Friday. 21 Replies

Latest Activity

Profile IconAndrew McDowell, Randy Kinnison, Breanna Detwiler and 8 more joined Home Energy Pros Forum
10 hours ago
David Butler replied to Brad Cook's discussion Too many Heat Pump Water Heaters in a basement?
"theoretically, let's say you perfectly isolate the HPWH from a heat source. The HPWH's…"
12 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"Interesting idea. Commercial roof on a slope! Typical density for roofing spray foam is 2.5 to 3.0…"
13 hours ago
Summer Redman added a discussion to the group Job Board
Thumbnail

Hiring 2 Training Specialists in Champaign-Urbana, Illinois

The Applied Research Institute (ARI) at the University of Illinois at Urbana-Champaign is seeking…See More
14 hours ago
Summer Redman joined Diane Chojnowski's group
Thumbnail

Job Board

This group is for posting jobs related to all aspects of the home performance industry including…See More
14 hours ago
Stacie Bagnasco replied to Evan Mills's discussion Dirty solar panels
"This is a great idea. I clicked on your discussion because it made me remember that I forgot to get…"
19 hours ago
Kirsten Richnavsky posted an event
Thumbnail

rCloud - The Future of Testing at Your Office or Home

October 18, 2017 from 2pm to 3pm
Integrating rCloud as an essential part of your RESNET QA process.Retrotec’s rCloud app is here,…See More
19 hours ago
Ed Whitaker replied to Brad Cook's discussion Too many Heat Pump Water Heaters in a basement?
"Brad,   I agree with the comments and would add a couple of thoughts. 1st,  any time you…"
20 hours ago

Photos

Loading…
  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service