Do you think the air loss will be minimal in the following situation

Underground duct with some separation at the joints, trenched and encased in pea gravel but surrounded with clay soil. There is also a 4" layor of pea gravel under the slab. The perimeter of the house is CMU block with clay backfill.

i.e. do you think the clay will stop the air flow leakage like clay stops water flow.

He wants to seal the ducts and I tell him he is wasting his money.

Views: 11552

Reply to This

Replies to This Discussion

So...the subslab duct is supply, which would provide dilution to the subslab zone through the existing air leaks. The non-operational system would provide pressure relief venting when the furnace is operating and potentially allow outside air to enter the gravel if stack affect is strong enough. The pipe sizes will only support 80 cfm, based upon my knowledge of the common fan curves used for radon. I suspect the fan is a Fantech HP220, which given the ability with duct size, will move more than 220 cfm . The savings numbers to me should also recognize the difference in ventilation caused by pressure changes either by the operating radon system or the HVAC system. I love that you can measure house tightness and pressure changes and develop a pretty good sense for the change in total flow.

 

Seriously, underground ducts?  I've never seen it done where it didn't end up with rotted ducts, condensation standing in the ducts and growing healthy mold, attracting rodents who like the conditioned and safe nesting areas, and becoming a conduit for radon.  They are a mess from an IAQ perspective and they perform very badly from an energy perspective.  As Nancy Reagan was fond of saying, "Just say No!"

look in to its like sewer liner

Air Duct Restoration

Duct Armor: Non-Destructive Air Duct Restoration

  • Non-toxic
  • Repairs rusty, moldy and deteriorated ducts
  • Quick and easy
  • 15 year transferrable warranty

A Quality Solution For Both Rust And Mold In Ducts Is Air Duct Restoration.

It,s put in buy the group who do sewer pipe restoration.  6" is the very min.  It,s about 1/4" thick I saw it done on 36" under ground PVC pipe  with 12" branch runs out of thick steel and boots out of 24 gage sheet steel.   I have seen the group put in large flue liner with the same tools-pumps.  using fire proof liner.  

most under ground duct are heat  only, and sized that way 

Uninsulated duct will require 150 btuh per linear foot of duct for heating.

1" insulated duct needs 90 btuh per linear foot for heating, 40% less energy

2" insulated duct will need 75 btuh per linear foot of duct pipe for heating, 50% less energy

Eric Kjelshus Energy 

Not sure how much if any air is leaking. If it is leaking where does it ultimately go? I agree, doubt it's worth messing with. If the A-coil is over 5 years old and not been cleaned, cleaning would yield a much quicker payback time.

I disagree with cleaning the A-coil being more effective than fixing or moving away from underground ducts.  Huge difference.

In ground ducting - if rotted out will leak air into the ground - even through the clay.  The clay may be impermeable to water but the air would move through it.  Trees grow in clay,  the roots need to breath.  Flood the clay field with trees on it they will die if the roots don't get air.  (yes there are trees that grow in swamps - but try growing a pine tree or spruce tree there....)

If the in ground ducts are leaky, the house may also have a dust problem,  moisture and mold problems... not caused by the A-coil, but a result of warm heated air in contact with the dirt and remnants of rotten duct work.

Not sure what Kevin has done,  but duct testing should be done - and then the hard decision is to try to fix or abandon and replace with something above the ground.

Mini splits would be my choice... but that may be difficult to explain to customer if they just replaced the furnace.  If so - build them a recommended replacement and if (when) the furnace fails - do it right at that time...

If the ductwork is damaged and/or has water in it, that needs to be addressed right away. If the ductwork is dry and not collapsed then go for the A-coil cleaning. Water in ductwork will show up as sauna like conditions in the winter if the leak is bad enough..

RSS

Forum Discussions

Why is Air Sealing Important?

Started by Cameron Home Insulation in General Forum 1 hour ago. 0 Replies

Greetings :)

Started by Dennis in General Forum. Last reply by Diane Chojnowski 16 hours ago. 2 Replies

Electro Magnetic Fields (EMF)

Started by Barry L NewDelman in General Forum. Last reply by Brad Cook 17 hours ago. 12 Replies

Zehnder Comfopipe vs. rigid pipe

Started by Alan Lehman in HVAC yesterday. 0 Replies

Follow the action at HPC 2018

Started by Diane Chojnowski in General Forum yesterday. 0 Replies

Latest Activity

Cameron Home Insulation posted a discussion

Why is Air Sealing Important?

Hello guys, Tell me, Why is Air Sealing Important? Share your views.Why is Air Sealing Important?See More
1 hour ago
Ryan T De La Rosa posted a blog post

Home Energy Savings In An Unlikely Place

When thinking of the best way to save mother nature, it's likely that the last thing on your mind…See More
8 hours ago
Taylor Joseph Mckay replied to Taylor Joseph Mckay's discussion Seeking to Purchase Blower Door in the group Energy Auditing Equipment for Sale, Trade or to Purchase
"please shoot me an email taylor.joseph.mckay@gmail.com"
10 hours ago
Diane Chojnowski replied to Dennis's discussion Greetings :)
"Welcome Dennis! Great to have you join us! "
16 hours ago
Brad Cook replied to Barry L NewDelman's discussion Electro Magnetic Fields (EMF)
"Whoa! EMFs are everywhere, but they are not all equal. The characteristics of EMFs varies very much…"
17 hours ago
Ben Thompson replied to Taylor Joseph Mckay's discussion Seeking to Purchase Blower Door in the group Energy Auditing Equipment for Sale, Trade or to Purchase
"Hi Taylor.  I have a Minneapolis Blower Door set up for sale. DG-700 manometer was factory…"
17 hours ago
Arn McIntyre replied to Taylor Joseph Mckay's discussion Seeking to Purchase Blower Door in the group Energy Auditing Equipment for Sale, Trade or to Purchase
"Taylor I have item described below for sale.  Pictures are posted in Equipment for…"
17 hours ago
Taylor Joseph Mckay added a discussion to the group Energy Auditing Equipment for Sale, Trade or to Purchase
Thumbnail

Seeking to Purchase Blower Door

Hi, I'm getting into energy audits and am looking to save a few bucks on picking up a used blower…See More
18 hours ago
Taylor Joseph Mckay joined allen p tanner's group
Thumbnail

Energy Auditing Equipment for Sale, Trade or to Purchase

Discuss the pros and cons of the equipment you are interested in prior to purchase. Post equipment…See More
18 hours ago
Sandra James replied to Barry L NewDelman's discussion Electro Magnetic Fields (EMF)
"I am quite interested in how EMF can cause health issues.  There is no question that too much…"
18 hours ago
Sandra James replied to Dennis's discussion Greetings :)
"Hello There, I am new as well. Hoping to learn new things through the course of this time on this…"
18 hours ago
Profile IconJames Sabal, Ethan Foley and Katelyn Haas Conrad joined Home Energy Pros Forum
19 hours ago
Alan Lehman posted a discussion

Zehnder Comfopipe vs. rigid pipe

Hello All,I have installed few Zehnder systems and I am not sure if my rep is giving me the info I…See More
yesterday
Diane Chojnowski posted a discussion
yesterday
Brett Little's 2 events were featured
yesterday
Profile IconSandra James, arthur wilson, Nolan and 4 more joined Home Energy Pros Forum
yesterday
Landon added a discussion to the group Energy Auditing Equipment for Sale, Trade or to Purchase
Thumbnail

BRAND NEW: Fantastic Software for Retrotec

I purchased a new blower door system from retrotec and it came with the fantestic software.…See More
Monday
CEE posted a blog post
Monday
CEE's blog post was featured
Monday
Brett Little posted events
Saturday

Photos

  • Add Photos
  • View All

© 2018   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service