Trends in space conditioning systems in high performance homes, looking for your insight

Can anyone comment on the common types of heating and cooling systems installed in their region in high performance homes?  More and more, I see designers and builders turning away from forced air and towards radiant hydronic or point-source systems (like mini-splits).  Reasons include mismatch between load and size of forced air furnaces, zoning control, lower pumping energy, distribution system takes up less space, better integration with solar thermal, etc.  Granted my scope is mostly California.  Can people comment from other regions about trends in conditioning systems in high performance homes?  Cheers!  

Views: 382

Reply to This

Replies to This Discussion

Mini-splits are excellent for homes with open floor plans. If a home has a lot of smaller rooms mini-splits don't do so well. Getting contractors to believe you can cool a 2,000 sq ft house with a 2ton central A/C unit can be a challenge.

Brennan,

Combi-systems for forced air is what we have been exploring in MN.  It is a compelling alternative to a separate furnace and water heater especially when the loads are low because you can add the heating load with the water heating load.  We obviously have much higher heating loads in MN, but I know that Dan and Gavin from Balance Point have been using this approach for low load homes in CA.  We have been mostly using a sealed combustion water heater combined with a hydronic air handler within the existing ductwork.  It would be much better with an appropriately sized/sealed duct system, but we are making it work in our existing since most of our ductwork is within the thermal boundary in MN.  Since we are using the water heater as the combustion unit, there is potential to hook up to a solar thermal array in certain products.  Let me know if you want any more info on this approach.  (Get my email from Iain).

Becky Olson

In California geothermal heat pump systems and air handlers with evaporative cooling.  In some instances, you can do with evaporative cooling alone without requiring mechanical cooling.  If you are in northern California, air side economizers are a must.  But I would say a lot of homes are going the geothermal heat pumps route because of federal rebates and when you purchase one it the price can be fixed into your mortgage instead of paying for the whole system at once.

You know I thought one day I would get a chance to share this story. A while back I worked for a buddy of mine on a big job for him putting in wall paper on a really nice 9 K sq. ft. home. The owner was very nice and obviously had retired well. He asked me what I did full time and said I,m trying to get an energy audit buisness off the ground. He informed me he retired from a regional sales buisness selling HVAC equipment. So I asked what he thought of any new trends in the industry. He told me to look outside and see the heat pumps...NINE ! outdoor units,they were in their own 4 ft deep concrete pits so they wouldn't be seen at eye level,split systems for 9K sq. ft......I came back in the house and told him " they look great!" and never spoke of matter again..Who am I to tell a guy with 30 yrs in the buisness and a 10mil. dollar home to show for it what he should do with his money. My point is 'know your market" in this situation.  

RSS

Forum Discussions

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler 11 hours ago. 15 Replies

Psychrometric Chart Training

Started by John Krochmalny in Training. Last reply by Mahendra Shah 14 hours ago. 1 Reply

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco on Monday. 1 Reply

Latest Activity

tedkidd replied to Bob Blanchette's discussion Tankless Water Heaters... has their time finally come?
"Yeah. Gas water…"
4 hours ago
Eric Kjelshus replied to Bob Blanchette's discussion Tankless Water Heaters... has their time finally come?
"With super cheap natural gas prices now, still worth going all electric?  Tankless needs a lot…"
5 hours ago
Stuart Langley liked Chris Clay's photo
10 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"Stuart, I wasn't considering the copula windows... yes, those would indeed need to be…"
11 hours ago
Stuart Langley replied to David Butler's discussion How would you insulate this roof?
"Well, @David Butler, you have seen the property more accurately than I have, but my impression of…"
11 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"@ Stuart,I don't think there's any concern about impact of 4" build-up on elevation…"
12 hours ago
Stuart Langley replied to David Butler's discussion How would you insulate this roof?
"So this building has a few issues with air leaks and air leaks have so much to do with discomfort…"
13 hours ago
Stuart Langley replied to David Butler's discussion How would you insulate this roof?
"John Hatfield has the right idea here for a new roof deck. Polyiso boards always need a good stout…"
13 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service