Treating crawl spaces (with ductwork) when the adjacent basement ceiling is insulated.

I am currently speaking with a homeowner who would like to replace the existing FG batt insulation in the ceiling above his crawl space. The crawl is connected to the basement, and the basement ceiling is insulated with FG batts as well. The crawl has ducts insulated to R-4.2 throughout it. The crawl floor is a thin layer of concrete (about 1").

I spoke to him of two options:

1. Slap R-19 un-faced FG batts in the ceiling, and then slap 1/2" to 1" of foil-faced rigid foam to the underside of the floor joists.

OR

2. (This is my preference). Lay down 6-mil poly across the floor of the crawl, and adhere the poly to the crawl walls (up a couple of feet). Then install 2" of foil-faced rigid foam to the crawl walls. 

I will also be insulating the rim\band joists throughout the basement.

Any advice?

Views: 268

Reply to This

Replies to This Discussion

I agree with your preferred option.  If the connected space is climate controlled then stopping moisture and outside air from entering is the best option.  Only putting the FG batts in the ceiling of the crawl space would still leave the influx of air to deal with and it would decrease the efficiency and comfort of the home.

Thanks Tim. I have been pushing this option, and I think the homeowner is going to bite.

I would suggest a true vapor barrier product or ASTM  E-1745

From my short education on the product you want to make sure that the product is rated for the application. It is critical that the product is mechanically fastened to the wall and sealed. If there are any piers the product should be fastened and sealed to it as well.All seams sealed with tape approved for the product

I use 1x2  and ramset for fastening and duct mastic for sealing.

It is tedious, boring and often unappreciated in a challenging space.

I would always be concerned about the walls ability to dry. If the outside stem wall is buried I would think twice before insulating it

That is some really valuable input Glen. I definitely will continue to think this one through.

Thanks.

Patrick

RSS

Forum Discussions

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler 18 hours ago. 15 Replies

Psychrometric Chart Training

Started by John Krochmalny in Training. Last reply by Mahendra Shah 21 hours ago. 1 Reply

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco on Monday. 1 Reply

Latest Activity

tedkidd replied to Bob Blanchette's discussion Tankless Water Heaters... has their time finally come?
"Yeah. Gas water…"
11 hours ago
Eric Kjelshus replied to Bob Blanchette's discussion Tankless Water Heaters... has their time finally come?
"With super cheap natural gas prices now, still worth going all electric?  Tankless needs a lot…"
12 hours ago
Stuart Langley liked Chris Clay's photo
17 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"Stuart, I wasn't considering the copula windows... yes, those would indeed need to be…"
18 hours ago
Stuart Langley replied to David Butler's discussion How would you insulate this roof?
"Well, @David Butler, you have seen the property more accurately than I have, but my impression of…"
18 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"@ Stuart,I don't think there's any concern about impact of 4" build-up on elevation…"
19 hours ago
Stuart Langley replied to David Butler's discussion How would you insulate this roof?
"So this building has a few issues with air leaks and air leaks have so much to do with discomfort…"
20 hours ago
Stuart Langley replied to David Butler's discussion How would you insulate this roof?
"John Hatfield has the right idea here for a new roof deck. Polyiso boards always need a good stout…"
20 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service