I have a 20 year old house with a 2 1/2 ton A/C for the lower floor and a 1 1/2 ton A/C for the upper floor. The 1 1/2 ton condenser went bad. The 2 1/2 ton is going bad.
I work for a commercial general contractor in Atlanta. We recently removed two functioning 5 ton Trane (5 years old) systems (cooling only) from an IT room. The room is being changed back into typical office space.
Is there a reason I can't replace my smaller units with these larger units? The IT room these units served was only 18'x20'x9' ceiling height. It felt as though you could hang meat in that IT room.
The refrigerant will need to change. I will have to add a gas heating element. Why can I not drive a race car down the road at typical driving speeds? Yes, it's more horsepower than needed but, what harm is there? Will I spend too much energy? Will the system freeze up? What?

Tags: BTU's, Too, many

Views: 186

Reply to This

Replies to This Discussion

If your space was designed for a 1.5 ton system, i find it hard to believe that you would consider a 5 ton. The furnace and coil to match if you found them would blow your windows out...way too much airflow. Can you say mold, mildew from short cycling and no humidity removal, energy consumption would be crazy, i could go on but this is a bad idea no matter how you look at it. The server room had a high heat load from servers and needed that size, i seriously doubt your standard residential home has that size load. 

Does the house ever feel clammy?
Do you have to keep the thermostat below 74 to be comfortable?
Is the duct noisy with the 600 cfm your current system needs?
If not, do you have ductwork that can handle 2000 cfm50 at 1/2 inch water column?

The 5 ton system you have is not 500 hp racecar engines they are 500 hp truck engines. The duct work is the transmission if you 3x the engines hp without upgrading the transmission you will have problems.

The undersized ducts will not move enough air and liquid refrigerant will likely get into the compressor and damage it.

Most air conditions have only 2 operation conditions 100% on or 100% off. Now lets imagin you want to drive your truck engine equipped Camry in stop and go traffic and your only speed control is engine 100 % or costing.  Your engine will get lots of very short run cycles.

Short run cycles are bad in 2 ways 1 it is hard on the equipment 2 AC equipment does not start removing humidity from the air until it has run for over 15 minutes.  Lots of people are comfortable 78° at 50% humidly. With short cycles you are more likely to end up at 78° at 80% and uncomfortable so the set point gets turned down and 68° at 70% is bearable most find it cold and clammy.

Also it can be bad for your health as the air in your ducts will likely be 25° below the set point. 43° ducts exposed to outdoor air will be well below the dew point water will pour off the duct and mold is possible

Do you think the 500 HP Camry gets better MPG?

 Walta

Its more about run time with high RH removing, than to large over sized AC unit, in houses.    The job I am working on now is started with 9 tons and will bring it down to 5 ton need.  Now the duct size is  right with just a total of of .5 SP just as the air handler is listed.   Most jobs I do have very large loads to start with and when I finish its much smaller load.  I see very high pressers and low CFM then the coil freezes on bad duct work jobs.   I have seen 400 SF IT rooms take 20 tons of cooling   and then change hard drives to more energy lowering now 9 tons and more speed.   Most IT rooms are high CFM and low RH removal.  

    

RSS

Forum Discussions

Psychrometric Chart Training

Started by John Krochmalny in Training 16 hours ago. 0 Replies

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler on Monday. 2 Replies

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco on Monday. 1 Reply

Latest Activity

David Butler replied to Brad Cook's discussion Too many Heat Pump Water Heaters in a basement?
"Hi Mike, it's good to get some feedback from the field, and thanks for confirming Gen 3 is now…"
5 hours ago
B Eric Bell liked Bob Krell's group Healthy Indoors (IAQ)
13 hours ago
John Krochmalny posted a discussion

Psychrometric Chart Training

Looking through the various areas of this site, I didn't see too much information or training on…See More
16 hours ago
Profile IconMike Malek, Avery T. Phillips and Sarah Burger joined Home Energy Pros Forum
17 hours ago
Dannie Jackson's blog post was featured

Core Heat And Other Concepts

  In some places the use of solar heated liquids from hot water solar panels are used to provide…See More
21 hours ago
Michael Duclos replied to Brad Cook's discussion Too many Heat Pump Water Heaters in a basement?
"I’ve been looking into Sanden for a multi-family PH near Laconia, NH, ASHRAE 99.6% temp is…"
21 hours ago
Profile IconTroy Spindler, Mike Berg, Andrew McDowell and 4 more joined Home Energy Pros Forum
yesterday
David Butler replied to Brad Cook's discussion Too many Heat Pump Water Heaters in a basement?
"theoretically, let's say you perfectly isolate the HPWH from a heat source. The HPWH's…"
Monday

Photos

Loading…
  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service