I am looking for a mechanical ventilation solution that is a step above the single supply or exhaust fan which is set to the required 62.2 rate. On the flip side, it must be something that is similar or just above the price for single supply/exhaust. 

Has anyone used an inline fan which is on a small 4-6in duct going from exterior fresh to return plenum? Seems like you could get an inexpensive low power fan along with a simple control which will run continuous (or intermittent according to 62.2 intermittent guidelines). I like this because you can then filter the air and distribute the air throughout the house. I don't want to use the air handler because the majority are not ECM motors and are too expensive to retro unless you are already replacing your AC.

I am looking for model numbers of the fan/controls you use for this.

Open to other suggestions and I know there are much better ways...yada yada...but I am specifically looking for an intermediate solution that doesn't bear the cost of dedicated ductwork or an expensive ERV/HRV, while being a step above simple exhaust/supply.

Thanks for your replies

PS - I am in Hot/Dry climate with primarily cooling loads

Views: 921

Reply to This

Replies to This Discussion

I do this all the time with just  a damper and  use the stat to move the damper as the timer.     When very cold or hot  some time will bring in to much air as the AC may not be big to off set the load extra.   I use a normal closed 4-5-6-7-8 in damper  then dump it into the return then the air cleaner  then air handler/furnace.   I use the Honey well IAQ stat what has 62.2 rate in it.      Down side with this is  on a 6" pipe 10' from outside will bring in 175 CFM next to outside wall - If the outside temp is to low I cranked a heat exchanger  the 1st  sub 0' night.   If its raining outside and damper is open  YOU can bring in 100% RH air  and can lower the total BTU's  on the AC side.   Just reset the Stat  for less open time.  This will make the building positive  and blows the dirt and stuff out.   In Midwest will raise the bill 15-25%  for both heat and cool.  

I don't really view this as viable solution due to the use of the air handler. If ECM motor may be ok, but otherwise to much energy hit from air handler motor. 

I did find a Panasonic WhisperLine Inline Ventilation Fan 120 CFM which pulls 36W and only 1 sone. Seems like this combined with a good controller and a damper would be a good way to bring fresh air into the duct system. Anyone see any potential problems? Maybe at a lower CFM setting it would draw less than 36watts?

Couple of things to think about with the ventilation supply to the return approach:

  1. The motor in your in-line fan will be effected by the big air handler blower which is likely to reduce its life which is the primary reason why this approach is usually just a pipe to the outside;
  2. The ventilation ducting is going to be small relative to the size of the house ducting.  The house ducting is (or should have been) designed to handle the larger volume of heating/cooling air (maybe 1000 cfm).  When the smaller flow blows through it, its velocity will be significantly reduced which may or may not be a good thing;
  3. When the air handler fan is not running, your supply air will circulate through the return ducting, missing the filter and conditioning elements, and may feel really drafty;
  4. It is really hard to determine how much ventilation air is actually being delivered to the house.

So one thing you might consider is the AirCycler's latest controls.  The G2 which operates the air handler blower that you can set up with the pipe to the outside, etc.  It will monitor the run time of the air handler for ventilation operation.  If the air handler has not run enough to satisfy the ventilation requirement, the ventilation function is transferred to the FanConnect control which turns on a bath fan to complete the need.  The power hungry HVAC fan doesn't run any more than it did before.  In the spring and fall, the bath fan will be the primary ventilation system, using much less power.

The hardest part of this is running the wires between the two controls.  And it's still hard to know how much ventilation air you are accomplishing, but its a thought.

Thanks for the input Paul. I think that will be a good solution and is better than just a fan alone.

Depending on the size of your house, this Panasonic ERV might do the trick:

http://www.panasonic.com/business/building-products/ventilation-sys...

paul your I like your answere

RSS

Forum Discussions

Efficiency of furnace

Started by Jignesh in General Forum. Last reply by Barbara Smith on Monday. 7 Replies

Best brands for furnace

Started by Jignesh in General Forum. Last reply by Barbara Smith on Monday. 1 Reply

Insulation Blower Recommendations?

Started by Jim Conlon in General Forum. Last reply by Cameron Home Insulation on Monday. 2 Replies

2005 EPAct tax credit

Started by Mandy Leazenby in General Forum. Last reply by Sean Lintow Sr Feb 15. 3 Replies

Latest Activity

Jacob Corvidae replied to Diane Chojnowski's discussion Support Mike Rogers in the group News & Announcements
"Hey Mike! We're all routing for you! Don't hesitate to ask for help.  Jacob"
22 minutes ago
Jacob Corvidae joined Diane Chojnowski's group
Thumbnail

News & Announcements

Share your news and announcements with the community in this group.To post news or an announcement,…See More
22 minutes ago
Diane Chojnowski added a discussion to the group News & Announcements
47 minutes ago
Profile IconJeannette Moore, David Carson, Jesse Smith and 3 more joined Home Energy Pros Forum
1 hour ago
Home Energy Magazine's blog post was featured

How We Turned Our House into a Giant Foam Box, Part I — Wall Insulation By Wen Lee

Chris Stratton and Wen Lee are a husband-and-wife team living in the Los Angeles area who are DIY…See More
17 hours ago
Home Energy Magazine posted a blog post

How We Turned Our House into a Giant Foam Box, Part I — Wall Insulation By Wen Lee

Chris Stratton and Wen Lee are a husband-and-wife team living in the Los Angeles area who are DIY…See More
17 hours ago
Chris Stratton replied to Chris Stratton's discussion Technical question about mini split heat pump line set maximum length
"Hi Chris, Thanks again for your help. Update: the system is now up and running. Chris"
20 hours ago
Home Performance Coalition's blog post was featured

From Philly to DC: Join Us on Capitol Hill

By now you have probably heard – as part of this year’s …See More
yesterday
Diane Chojnowski added a discussion to the group News & Announcements
Thumbnail

Nominate a visionary leader for the Linda Wigington Leadership Award

The Linda Wigington Leadership Award celebrates visionary leaders doing extraordinary work to…See More
yesterday
Home Performance Coalition liked Chris Morin's blog post HVAC: A Fast Growing Career Opportunity
yesterday
Home Performance Coalition liked Diane Chojnowski's blog post Home Performance Coalition Calls on Congress to Support Federal Energy Efficiency Programs
yesterday
Home Performance Coalition liked Home Energy Magazine's blog post Andrew Scatizzi- Stick to the Basics in New Construction
yesterday
Home Performance Coalition posted blog posts
yesterday
Safe-R Insulation commented on Safe-R Insulation's blog post What are the advantages of Cavity Wall Insulation?
"Hi, Cavity wall insulation are more effective and increase wall life. And it will also help to save…"
yesterday
Profile IconMichael R. Johnson and Jerry Phillips joined Home Energy Pros Forum
yesterday
Sara Watson posted a blog post

6 Tips to Pick Out The Best Solar Outdoor Lights

You have a beautiful home in Florida and plan to add a little sparkle to your front garden, patio,…See More
Tuesday
DesignTech liked DesignTech's photo
Tuesday
Anthony Roy is now a member of Home Energy Pros Forum
Monday
Barbara Smith commented on Barbara Smith's video
Monday
Barbara Smith replied to Jignesh's discussion Efficiency of furnace
"Installation and proper sizing is important to getting the best performance out of your furnace.…"
Monday

Photos

  • Add Photos
  • View All

© 2018   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service