This month's stump the chump comes from a mystery contributor, a caped crusading building performance specialist from Burlington, Vermont.

During a recent job, the crusader was reminded of a stumper he encountered in the late 1990's.

The homeowners of a 19th century duplex were in trouble; victims of uncomfortable rooms and high energy bills. With their patience wearing thin, they called in the local home performance hero to upgrade the shell of their home. The scope of work included significant infiltration reduction; upgrading thin rockwool attic insulation to R40; dense-packing 2x6 finished slanted ceilings with cellulose; dense-packing 2x4 exterior walls with cellulose; dense-packing the perimeter of the 2nd floor framing system with cellulose; R19 bandjoist insulation; and a few other minor things.

Click here to read more.

Tags: BPI, Chump, Stump, the

Views: 408

Reply to This

Replies to This Discussion

What happened to my reply? What I had posted was that this month's stumper was a coincidence in that I am presently working on a similar home. The home I'm working on also has high heating bills, uncomfortable rooms, and a one pipe steam heating system. I'm thinking the solution is to install thermostatic radiator valves in the overheated rooms. Those upstairs rooms feel like a sauna, even though the first floor, where the t-stat is, is only at 72 degrees f. Having the rest of the home at a higher delta T to outside greatly increases heating costs. 

It is still there - it just happens to be under the BPI group where they pasted the exact same question, etc... Eventually they will learn net etiquette, but until then...  

I am also very interested in the comments as I have been living in a 1930's two-story home with a single-pipe steam/natural gas system for over 30 years.  I have also done some extensive air sealing and insulating (but I know more can be done) but we HAVE seen a tremendous decrease in our natural gas usage. Since the clues are that the amount of gas used has not changed even after all the remediation, it seems there is still a large loss of heated air (so that the heating system needs to make that up). My guess (based on an assumed age of the dwelling because of a single-pipe system) is that there is a fireplace flue (or 3) that are mostly/completely open and now (with the remediated air leakage work) are flowing even more air 24/7. If so, I'd recommend inflatable flue blocking devices for all fireplace flues. 

You may very well be right, considering the fact that they usually leave something out in those quiz questions, or deliberately mislead, such as they say they accomplished "significant infiltration reduction". It would not surprise me for them to come out with the answer as "there was significant infiltration increased".

I'm thinking the crusader eliminated one of the two steam boilers (or resized and installed a new, high
efficiency boiler) to handle heating both units in the duplex.  By incorporating zone valves and
separate thermostats, the clients no longer have to run two separate boilers
(both of which may have already been oversized), to efficiently heat the entire
duplex.

Perhaps the 2nd time around the local home performance hero (LHPH) decided to insulate the heating pipes and / or the foundation walls.  I am of course assuming the pipes were probably proximate to an un-insulated / un-air sealed foundation. 

Somebody want to tell me how much the final "simple upgrade" cost? What was the SIR on that upgrade? I would venture to say that this upgrade was very non-cost-effective. BPI should be promoting cost-effective remedies. Replacing a working steam boiler with a hot water boiler, along with an expensive repiping of the radiators is not a cost effective solution. They could have achieved 30% savings just with installing TRV's, and with a simple payback of one or two seasons, as opposed to the likely-to-never-have-a-payback upgrade endorsed in the Stump the chump game. 

Well it just came out & I quote... "He explains that our crusader “upgraded the two single pipe steam boilers to hot water boilers by modifying the distribution piping and adding a pipe to each of the radiators.  This allowed the boiler to heat the space without having to boil the water to make steam, which uses much less energy.  With the above upgrades, and keeping in mind that only hot water boilers can be low mass, which modulates output design, the savings can be quite substantial."

Then it sounds like he kept the existing boiler? I read it wrong then; my bad. 

OK - he kept the boilers, but the labor to extend the returns to every radiator would have been a tremendous labor/material cost (not to mention eyesore). And how did the hot water get to the radiators?  He would have needed to add at least 2 circulation pumps (1 for each system); maybe 2 manifold systems (1 for each system) too if the home owner wanted more than 1 zone. Unless he was relying on thermo siphon action. I really have a hard time believing that any net savings occurred here.

RSS

Forum Discussions

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler yesterday. 2 Replies

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco yesterday. 1 Reply

Fixing a water heater?

Started by John Shillito in Best Practices. Last reply by Eric Kjelshus on Friday. 21 Replies

Latest Activity

Profile IconAvery T. Phillips, Sarah Burger, Troy Spindler and 2 more joined Home Energy Pros Forum
11 hours ago
David Butler replied to Brad Cook's discussion Too many Heat Pump Water Heaters in a basement?
"theoretically, let's say you perfectly isolate the HPWH from a heat source. The HPWH's…"
yesterday
David Butler replied to David Butler's discussion How would you insulate this roof?
"Interesting idea. Commercial roof on a slope! Typical density for roofing spray foam is 2.5 to 3.0…"
yesterday
Profile IconRandy Kinnison, Breanna Detwiler, Jeff Farlow and 7 more joined Home Energy Pros Forum
yesterday
Summer Redman added a discussion to the group Job Board
Thumbnail

Hiring 2 Training Specialists in Champaign-Urbana, Illinois

The Applied Research Institute (ARI) at the University of Illinois at Urbana-Champaign is seeking…See More
yesterday
Summer Redman joined Diane Chojnowski's group
Thumbnail

Job Board

This group is for posting jobs related to all aspects of the home performance industry including…See More
yesterday
Stacie Bagnasco replied to Evan Mills's discussion Dirty solar panels
"This is a great idea. I clicked on your discussion because it made me remember that I forgot to get…"
yesterday
Kirsten Richnavsky posted an event
Thumbnail

rCloud - The Future of Testing at Your Office or Home

October 18, 2017 from 2pm to 3pm
Integrating rCloud as an essential part of your RESNET QA process.Retrotec’s rCloud app is here,…See More
yesterday

Photos

Loading…
  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service