Stopping Air Infiltration at Cable / Phone Line Entry

This is an entry point for cable TV coax, phone lines and a couple of grounds. They exit the basement of this home through a hole drilled in the foundation.

The air infiltration at this opening is significant. There is effectively a open path to the outside between every cable. If you flex the cables a bit you can see sunlight.

 

I'm struggling with how to stop the airflow. My first thought was expanding foam but that could be a mess and not guarantee that the leaks would be filled.

 

I searched the web but mainly came up with industrial products for outdoor utility boxees.

Any suggestions?

 

Thanks for your help,

 

Johnny

 

Johnny on Energy - Helping you improve your home energy efficiency.

Views: 221

Reply to This

Replies to This Discussion

Gosh, that's a lot of wires.  If there weren't quite so many, I'd suggest making a foam gasket so that each wire passed through its own hole.

 

How about if you attached a zip tie to the bundle of wires on one side of the wall to immobilize them, and then on the opposite side peeled the wires apart one at a time and injected caulk between them, then bundled them back together (squishing the caulk) and zip tied that end?  That would seal all the gaps between wires, leaving you with only the outside of the bundle to seal.  Of course, getting any wires in or out after that would be nearly impossible.

 

Looking forward to hearing other people's suggestions.

With access like that, I'd try pushing into gaps appropriate lengths of wooden dowel of various diameters, to function like shims and fill those gaps.  Clean and reversible.  If it doesn't work, pull them out and try another's suggestion.

RSS

Forum Discussions

Home Energy Pros and #MeToo

Started by Mike Rogers in General Forum 10 hours ago. 0 Replies

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler yesterday. 34 Replies

Psychrometric Chart Training

Started by John Krochmalny in Training. Last reply by Mahendra Shah on Friday. 1 Reply

Latest Activity

Blake Shurtz posted a discussion

Replacement for Energy Conservatory Flow-blaster

It's too bad that the flow-blaster is no longer being produced or technically supported. Does…See More
4 hours ago
Profile IconBrian Cizmar, Charles Allen, Charles Buell and 1 more joined Home Energy Pros Forum
7 hours ago
Mike Rogers posted a discussion

Home Energy Pros and #MeToo

If it doesn't seem obvious why a discussion of …See More
10 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"Sean Lintow proposed rails and clips (re: first comment in this discussion), but in the context of…"
yesterday
Brad Cook replied to David Butler's discussion How would you insulate this roof?
"I missed where the suggestion for rails came in. The plywood would not need any rails. 4+ inches is…"
yesterday
David Butler replied to David Butler's discussion How would you insulate this roof?
"I'm a little confused about the necessity and purpose of using support rails if working on…"
yesterday
David Butler replied to David Butler's discussion How would you insulate this roof?
"If you insulate master bedroom and family room from below, you definitely need more R-value than…"
yesterday
David Butler replied to David Butler's discussion How would you insulate this roof?
"Brad, I was only talking about using EPS between the ridges, if necessary, to conform to bolts.…"
yesterday

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service