Good morning all,

We had a question come up on "shielding insulation." The description is as follows: 

"The Universal Shielding Insulation is used to reduce cold air infiltration into the dwelling and to provide additional protection against radiant heat from the chimney or venting system."

That description is vague enough to make me very skeptical--radiant barrier skeptical. Has anyone encountered this and able to validate or invalidate its usefulness?

Views: 220

Reply to This

Replies to This Discussion

A bunch of marketing terms is all that it sounds like - without specs or anything else to discuss we are only guessing. As for dispelling myths & bad marketing terms, I do it all the time while trying not to give any link or seo love to the offenders by explaining what a radiant barrier really does, etc...

It does not ring a bell.

Wait...it does, an alarm bell.

Anything, insulation, equipment, material that does give stats in industry standards, in this case, R, U, or even "equals --- inches of fiberglass", up front, readily accessible in seconds, should be relegated to the bottom of the stack of papers you'll get to "someday". 

Physics pretty much determines what makes insulators work, and short of layering alternate realities in between two layers of craft paper, we are unlikely to see any "new" forms of insulation.  Hmmmm, or would that just bleed heat between realities?????

Well, it's part of Selkirk's chimney or venting package, and "may be installed within an Attic Insulation Shield, a Wall Thimble or a Cathedral Ceiling Support" as  a way to reduce air leakage at that nastiest of places: where a chimney leaves the building envelope and must be separated from combustible materials which must be protected against radiant heat. For that use, it is both UL and Warnock Hersey listed. It's not meant for anything else. End of story. It's not a scam, rip off or bubble wrap silver bullet.

RSS

Latest Activity

Chris Dorsi posted an event
Thumbnail

2018 Habitat X Summer National Conference at Big Sky Montana

June 27, 2016 to June 29, 2016
The 2018 Habitat…See More
7 hours ago
Stuart Langley liked David Byrnes's blog post Strategies for Hiring and Interviewing for Home Performance Professionals
11 hours ago
Kevin Miller replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"Visual inspection can only confirm the presence of mold, not the absence.   That said,…"
14 hours ago
Armand C Magnelli replied to Don Fugler's discussion joining ducts in the group HVAC
"I often suggest pop-rivets as an alternative to sheet metal screws for both clothes dryer duct work…"
15 hours ago
Kevin Miller replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"Sampling would be primarily to verify 'Condition 1' or 'Normal Fungal Ecology'…"
15 hours ago
Daniel Cullen joined Building Performance Institute's group
Thumbnail

Building Performance Institute (BPI)

BPI is the nation's premier standards development, quality assurance and credentialing organization…See More
15 hours ago
Daniel Cullen replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"Can anyone tell me exactly HOW mold sampling impacts the mold remediation process or protocol? Why…"
15 hours ago
Daniel Cullen joined Bob Krell's group
Thumbnail

Healthy Indoors (IAQ)

The Healthy Indoors group is focused on indoor air quality (IAQ), mold, moisture control, radon,…See More
15 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service