Good morning all,

We had a question come up on "shielding insulation." The description is as follows: 

"The Universal Shielding Insulation is used to reduce cold air infiltration into the dwelling and to provide additional protection against radiant heat from the chimney or venting system."

That description is vague enough to make me very skeptical--radiant barrier skeptical. Has anyone encountered this and able to validate or invalidate its usefulness?

Views: 218

Reply to This

Replies to This Discussion

A bunch of marketing terms is all that it sounds like - without specs or anything else to discuss we are only guessing. As for dispelling myths & bad marketing terms, I do it all the time while trying not to give any link or seo love to the offenders by explaining what a radiant barrier really does, etc...

It does not ring a bell.

Wait...it does, an alarm bell.

Anything, insulation, equipment, material that does give stats in industry standards, in this case, R, U, or even "equals --- inches of fiberglass", up front, readily accessible in seconds, should be relegated to the bottom of the stack of papers you'll get to "someday". 

Physics pretty much determines what makes insulators work, and short of layering alternate realities in between two layers of craft paper, we are unlikely to see any "new" forms of insulation.  Hmmmm, or would that just bleed heat between realities?????

Well, it's part of Selkirk's chimney or venting package, and "may be installed within an Attic Insulation Shield, a Wall Thimble or a Cathedral Ceiling Support" as  a way to reduce air leakage at that nastiest of places: where a chimney leaves the building envelope and must be separated from combustible materials which must be protected against radiant heat. For that use, it is both UL and Warnock Hersey listed. It's not meant for anything else. End of story. It's not a scam, rip off or bubble wrap silver bullet.

RSS

Forum Discussions

What made this chimney fall down?

Started by Eric Kjelshus in General Forum. Last reply by Eric Kjelshus on Tuesday. 7 Replies

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by Dave Taylor on Sunday. 61 Replies

Manual J (SD) for custom, luxury homes

Started by Dav Camras in HVAC. Last reply by Dav Camras Nov 10. 3 Replies

Quantitative methods for residential zoning

Started by Brett in HVAC. Last reply by David Butler Nov 9. 1 Reply

Home Energy Pros and #MeToo

Started by Mike Rogers in General Forum. Last reply by Mike Rogers Nov 9. 3 Replies

Latest Activity

Profile IconSonny Roncancio and Chester Energy & Policy joined Home Energy Pros Forum
5 hours ago
Ryan Moore updated an event
Thumbnail

LEED for Homes Green Rater Training at Fort Collins, CO

December 7, 2017 to December 8, 2017
Green Insight will host this 2-day training in Fort Collins, CO December 7-8,…See More
yesterday
Rodney Bailey liked Rodney Bailey's discussion Energy audit equipment for sale.
yesterday
tedkidd liked Mike Rogers's blog post Focusing on payback to motivate customers?
yesterday
Home Energy Magazine's blog post was featured
Wednesday
Home Energy Magazine posted a blog post
Wednesday
Quinn Korzeniecki added a discussion to the group Building Performance Institute (BPI)
Thumbnail

Rebates and Incentives: Illinois

Curious about home performance incentives and rebates available in your area? Check out this BPI…See More
Wednesday
Profile IconStacey Cordeiro and Melissa Ames joined Home Energy Pros Forum
Wednesday

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service