I've been reading a lot of info from Europe on rock wool. It is claimed to be close in R-value to foam and much greener with open vapor. I am interested in using for exterior and basement insulation. Does anyone have experience using rigid rock wool? Thanks.

Views: 512

Reply to This

Replies to This Discussion

Hi Richard,
I'm not sure about your reference to "Ridgid" rock wool. I'm somewhat familiar with Roxul which is a high density cavity insulation and I like it. As for basements, there are SO MANY other considerations, but yes, for a layer inside of some rigid foam panels it looks good.

Bud

Rock wool is available in rigid product, with various densities, depending on application.

There is a product designed as drain board for foundations.

It's available in pipe insulation, batts, and blown in. Although you may have a hard time finding or getting.

Look for industrial / commercial / wholesale insulation suppliers.

It's fireproof & waterproof, lower embodied energy than foam, but has formaldahyde glues still.

I have used a few brands of rigid batts for air sealing and found the Roxul brand better. Roxul is more dense and easier to cut  and we use it frequently for air sealing in areas where foam will not work and some chase areas. Most brands are marketed as acoustical batting,  however I have seen Roxul reps at the big box stores promoting the product for general attic/wall insulation against fiberglass. For attics cellulose is more cost effective and any rigid  batt (rock wool or fiberglass) used in attic insulation  is problematic. Rock wool has great thermal characteristics and does not wick water making it a good choice for basements and exterior applications. My only complaint is rock wool (slag) fibers are nasty.

Thanks Jose

For exterior application do you attach directly or with drainage plane?

I have not used Roxul for exterior applications- only airsealing and basements. Check their website as I believe Roxul offers additional products specifically for exterior applications

RSS

Latest Activity

Dara Bowser replied to Don Fugler's discussion joining ducts in the group HVAC
"Good to hear you have clean dryer ducts Don. The dryer duct issues that we run into are…"
4 hours ago
Don Fugler replied to Don Fugler's discussion joining ducts in the group HVAC
"David, If the IMC mandates metal dryer duct and prohibits metal screws, they must be accepting…"
5 hours ago
David Butler replied to Don Fugler's discussion joining ducts in the group HVAC
"I never checked that before. Checking now... Section M1502.4.2 of the International Residential…"
5 hours ago
Joseph Frasier is now a member of Home Energy Pros Forum
5 hours ago
Don Fugler replied to Don Fugler's discussion joining ducts in the group HVAC
"Brendan, Thanks for that response. Because of your warning, I just went down to the basement and…"
9 hours ago
Brendan Reid replied to Don Fugler's discussion joining ducts in the group HVAC
"Hi Don, Summary: DRYER VENT: screws bad idea, possibly prohibited by code. METAL DUCT: must be…"
9 hours ago
Profile IconBrendan Reid and David Butler joined Allison A. Bailes III's group
Thumbnail

HVAC

HVAC design, Manuals J, S, T, & D, Duct leakage, Air flow, ENERGY STAR new home requirements,…See More
9 hours ago
Profile IconSean Wiens and David Butler joined Chris Laumer-Giddens's group
Thumbnail

Energy Efficient Design

Energy efficiency starts at the drafting table...How architects and designers can help buildings…See More
18 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service