I've lived in both North Carolina and Minnesota. I installed a radiant barrier in North Carolina and was very impressed by the results. Now in Minnesota there are only about two months that are hot enough to warrant it. Does radiant barrier help in any way in the winter?

Views: 2284

Reply to This

Replies to This Discussion

I'm in eastern Kansas, and I hung a radiant barrier from the attic rafters above part of my south-facing roof.  The entire south-facing part of the roof gets equal sun exposure, and the whole attic has equal insulation.  The part with the radiant barrier has consistently been the last (of the south-facing part of the roof) to thaw after snowfall this year.  How much heat savings that represents, I don't know.
Something there I suspect. I'm trying to find if anyone has done any research on this. Anybody know?

Hi Ross.  I have been working with a radiant barrier coating for 25-years now.  Our coating goes on like paint, looks like paint and can be used as interior or exterior paint or as a roof coating.  What makes ours exceptional is that it is not only a radiant barrier, it is an extremely effective as a conductive heat barrier also. 

It retains heat in the winter.

 

I will be happy to send you a small cured sample if you would like to experiment with it.

 

My contact information is on my profile, so is our websites.

 

Hal

There are two factors I can think of when talking about radiant barriers:

1) Radiant barriers reflect heat both ways (in the winter they preserve the heat inside, which might be good)

2) When installing a radiant barrier right under the roof it will work to raise the temperature of the roof, which is also a problem if you have just a hot roof. And the problem is - your roofing will not last nearly as long when it's this much hotter. The way to go is to make the roof surface reflective.

Hi Jack.

 

I have 25 years of working with our radiant barrier coating / paint.  We do every type of residential and commercial roof except wood shingles.  I agree with you that a reflective barrier beneath a roof will make the roof hotter and give it a shorter life than expected.

 

However, when it comes to a radiant barrier coating applied to residential sloped roofs, hardly anyone wants a bright white roof.  It shows evert little bit of dust, every pine needle and spot of bird poop, the neighbors hate it.  We normally tint it with a few drops of brown, blue, or green and then the neighbors dont seem to mind.

 

Our coating is nor just a very effective radiant barrier, it is also an extremely effective conductive heat barrier.

 

Now, nefore I start on this aspect I want to state that if you talk about a radiant barrier roofing material that gets temperature reductions and resulting energy calculation that come out to more than 10% to 15%, people think you are nuts.  We get calcs of 50%+ and have been getting that for 25 years.

 

As a conductive heat barrier, our coating has been applied on top of the black felt paper on new roofs and re-roofing projects and results in temperature reduction that come out to 38% to 50% year round.  It can also be applied to the plywood before the black felt it installed and the same results.

 

We have found out over the years that by painting the sheetrock walls and ceilings in the building is the most effective way to uitilize our product and get the maximum energy savings year round.

 

We have had our reflective coating on the roofs of casinos in Las Vegas for over 20 years and they are just as effectrive and look the sam as the first week they were installed.

 

As far as applying ours to the felt or the plywood under the felt, their is no protection from the UV rays to the shingles as they  will absorb that heat energy and will be unable to trasfer it to the inside of the building.  That equals a hotter shingle and a reduced lifespan of the shingle.

 

We have alot of information on our website on what we do.

 

 

 

Hal, your company does business on the West Coast primarily, as I see. Is there anything like that on the East coast that you would know of or maybe one can buy the product you are using somewhere and apply himself?

Our distributor in Texas can go anywhere in the US.  It will never be available 'Off the shelf".  It is a specialty coating and an elastomeric.  If people treat it like paint, they will have some problems.  It is 30 times thicker than paint, 65% solids.  The formula is very sensitie to the addition of water, even though it is water based.  Add 1 cup of water to a 5 gallon buchet and you just ruined it, it will lose its elastomeric properties and will not bond well.

 

We have a sales representative in Maryland.  Our distributors in Texas or California can ship it anywhere.

 

Hal

Ross;

 

At the risk of drawing the ire of the folks on here who sell radiant barrier products, everything I've learned has told me that a radiant barrier in cold climates like ours (I'm in Iowa) is a waste of money.  We have had a number of firms selling various products in our area, and I've run across it in several home energy audits.  In one case, a customer spent over $3,000 to put a radiant barrier on top of his attic floor when all he had in the floor cavity was 4" of cellulose!  In other words, for a third of the cost he could have increased his attic R value to R-49+ and saved WAY more energy than the radiant barrier would save him!

 

Here's a link to a fantastic article about radiant barriers that you should read:  http://www.greenbuildingadvisor.com/blogs/dept/musings/radiant-barr...

Thank you so much for directing me to this article. It is clear, the best practice is to put your money into insulation. I like the fact that the writer sited some studies he had found.

 

Thanks again!

Absolutely!
Don't forget about air-sealing!

No.

the US DOE at Oak Ridge National Lab, ONRL, have done some good work documenting the value of these in all 8 climate zones. See the web page at http://www.ornl.gov/sci/ees/etsd/btric/RadiantBarrier/index.shtml

It also has a good "pdf" of the article.

Living in Minnesota myself I can appreciate the lure of a "silver bullet", but this aint it.

As others have said: Air seal and insulate are they way to go in Our climate zones of 6 & 7. 

RSS

Latest Activity

Chris Dorsi posted an event
Thumbnail

2018 Habitat X Summer National Conference at Big Sky Montana

June 27, 2016 to June 29, 2016
The 2018 Habitat…See More
6 hours ago
Stuart Langley liked David Byrnes's blog post Strategies for Hiring and Interviewing for Home Performance Professionals
10 hours ago
Kevin Miller replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"Visual inspection can only confirm the presence of mold, not the absence.   That said,…"
13 hours ago
Armand C Magnelli replied to Don Fugler's discussion joining ducts in the group HVAC
"I often suggest pop-rivets as an alternative to sheet metal screws for both clothes dryer duct work…"
13 hours ago
Kevin Miller replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"Sampling would be primarily to verify 'Condition 1' or 'Normal Fungal Ecology'…"
13 hours ago
Daniel Cullen joined Building Performance Institute's group
Thumbnail

Building Performance Institute (BPI)

BPI is the nation's premier standards development, quality assurance and credentialing organization…See More
13 hours ago
Daniel Cullen replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"Can anyone tell me exactly HOW mold sampling impacts the mold remediation process or protocol? Why…"
14 hours ago
Daniel Cullen joined Bob Krell's group
Thumbnail

Healthy Indoors (IAQ)

The Healthy Indoors group is focused on indoor air quality (IAQ), mold, moisture control, radon,…See More
14 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service