Question from energy homeowner:

 

Contractor has recommended installing a two stage Water Furnace Envision w/desup NDV049A system into a 2700 square foot cape cod, 1000 square feet basement, 1000 square feet first floor, and a 700 square foot second floor.  The house is all brick and was built in 1950, walls and attics are currently insulated using r 11.  The blower door test gave a  2800 cfm reading at 50.

 

Contractor is recommending a 4 ton geothermal system, According to his comments it is a two stage system that  will run at 60% capacity at the first stage and 100% at the second stage.  Contractor feels the 4 ton system will provide more heat using the geothermal without going to the back up heat.,

 

If the system is over-sized to accommodate the heating season, does this make sense.?  He says with a two stage system it does.  Will the system operate efficiently.  If we were installing a regular electric heat pump the manual J test called for a 3 ton system  (single stage)   Is the contractor correct in over-sizing the unit to provide more geothermal heat in the winter months?

 

One other question: What is the advantage of using galvanized ducts as compared to 1 inch rigid fiberboard ducts?

 

Thank you for responses

 

 

 

Views: 1445

Reply to This

Replies to This Discussion

Hi my name is Steve.

If the manual J suggested a 3 ton I would look at a 3 ton two-stage. The two stage units are usually a 1/2 ton larger in size. When I size my units, I try to shoot for a balance point of 5 to 10 degrees outside temperatures here in Michigan. The operating cost seems to be the best at these temps (even with the little back up thats needed). The reason is the larger compressors use most electricity. Now, it's not a lot of difference in operating cost. Having the next size larger is not devastating but you need to have larger duct system and extra loop installed driving up installation cost.

My question is? Did the contractor you are referring to complete a manual J load and does he know where his balance points are. If he can not show you he calculations he is guessing and not doing you a good job.

Note: The home generates a certain amount of heat and you can design at 77% of the calculated load. So if the manual J says you can install a 3 ton then it does not matter if it it two stage or not. Sorry I have to go now my wife i waiting, You can contact me if you have more questions at performancegeothermal@gmail.com.

Steve Shannon

PS, I like sheet metal for duct work.

If the contractor doesn't calculate a manual J,D, and S worksheet for the house then he's merely guessing. Also, galvanized ducting last much longer, is easier to clean, and is more rigid that fiberboard.

RSS

Forum Discussions

Too many Heat Pump Water Heaters in a basement?

Started by Brad Cook in General Forum. Last reply by David Butler 18 hours ago. 9 Replies

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler 19 hours ago. 2 Replies

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco yesterday. 1 Reply

Fixing a water heater?

Started by John Shillito in Best Practices. Last reply by Eric Kjelshus on Friday. 21 Replies

Latest Activity

Profile IconTroy Spindler, Mike Berg, Andrew McDowell and 4 more joined Home Energy Pros Forum
14 minutes ago
David Butler replied to Brad Cook's discussion Too many Heat Pump Water Heaters in a basement?
"theoretically, let's say you perfectly isolate the HPWH from a heat source. The HPWH's…"
18 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"Interesting idea. Commercial roof on a slope! Typical density for roofing spray foam is 2.5 to 3.0…"
19 hours ago
Summer Redman added a discussion to the group Job Board
Thumbnail

Hiring 2 Training Specialists in Champaign-Urbana, Illinois

The Applied Research Institute (ARI) at the University of Illinois at Urbana-Champaign is seeking…See More
20 hours ago
Summer Redman joined Diane Chojnowski's group
Thumbnail

Job Board

This group is for posting jobs related to all aspects of the home performance industry including…See More
20 hours ago
Profile IconCrystal McLain, Robert Grindrod, Rich Wickman and 3 more joined Home Energy Pros Forum
yesterday
Stacie Bagnasco replied to Evan Mills's discussion Dirty solar panels
"This is a great idea. I clicked on your discussion because it made me remember that I forgot to get…"
yesterday
Kirsten Richnavsky posted an event
Thumbnail

rCloud - The Future of Testing at Your Office or Home

October 18, 2017 from 2pm to 3pm
Integrating rCloud as an essential part of your RESNET QA process.Retrotec’s rCloud app is here,…See More
yesterday

Photos

Loading…
  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service