Looking for some insight on proper insulation methods. We will be building a raised wood framed floor above an existing concrete slab garage floor. Converting the garage into a bedroom. The heat will be hydronic in floor radiant, we will have 9-10" from concrete to the top of sub floor.Current thoughts are EPS on the floor sealing all seams and perimeter W/ Roxul bats in the joist cavity then a layer of radiant under the sub floor.

Views: 142

Reply to This

Replies to This Discussion

Matthew, if you use 2 lb EPS or 25psi in two layers staggered layers 4" overall then you can put a 2x4 flat for bearing. This allows for smaller joist while giving you R20 minimum. Then between the joist I would put any batt insulation but put a foil bubble foil product to reflect the heat upward with pex tubing. This will be the most efficient for least cost. The inability to staple upward to the subfloor is why I recommend the foil bubble foil. Also tape the seams. THE CLOSER to the subfloor with the foil the better.

I have done this before. We did not use hydronic heat or radiant barrier. We used all EPS foam leaving a small half inch gap between foam and wood framing to foam in w a can. Yes we cut and filled the whole framed cavity as well as a 2" EPS continuous taped under everything. 

Just make sure the EPS is highest PSI rated possible. Usually the 2" comes in the highest PSI rating. 

Pay attention to a vapor barrier. You will have one'ish the bottom so make sure the cavity can breath into conditioned space. So put the radiant barrier reflecting upward on top of the EPS. Like what Dave Taylor said. Dont sandwich the cavity w 2 vapor barriers.

Roxul is amazing stuff?

I ment Roxul is amazing stuff!

Thank you for your insight.

Thank you for your insight.

Proper insulation methods.

Blanket: Batt and Roll Insulation
Fiberglass Batt Insulation Characteristics
Concrete Block Insulation
Foam Board or Rigid Foam
Insulating Concrete Forms
Concrete Form Association.
Loose-Fill and Blown-In Insulation

RSS

Latest Activity

Pearl Certification posted a blog post

New Study Measures Impact of Energy Efficient Features On Home Sale Prices in Phoenix

City of Phoenix, APS and RESNET Join Pearl Certification and HomeSmart In Launching Innovative Home…See More
3 hours ago
Amber Vignieri posted a blog post

New Video Explains the Super Stars of Energy Efficiency: Air Sealing and Insulation

Air sealing and insulation are the celebrities of the high-performance home world (high performance…See More
3 hours ago
Brett Little posted an event
Thumbnail

The Smart Enclosure System: Building in the Anthropocene - Free CE Webinar at Webinar Online

January 23, 2019 from 12pm to 1:15pm
The Smart Enclosure System offers a 21st-century guide to advanced high-performance building…See More
4 hours ago
Franco Oyuela replied to Matthew Greenawalt's discussion Proper means of insulating raised floor above concrete
"Proper insulation methods. Blanket: Batt and Roll InsulationFiberglass Batt Insulation…"
5 hours ago
Profile IconAnn McCartan, Dimitri Mal, Richard Barlow and 3 more joined Home Energy Pros Forum
8 hours ago
Luke Langhals replied to Don Fugler's discussion Depressurization/make-up air issues in the group Kitchen Ventilation
"I've seen both work with success, really it comes down to duct design/placement. It would…"
10 hours ago
Diane Chojnowski posted an event
Thumbnail

EEBA: High Performance Home Summit at San Diego

October 16, 2019 to October 18, 2019
Join us in sunny San Diego, October 16-18, at the MUST-ATTEND event of the year for builders,…See More
10 hours ago
Ryan Miller's event was featured
Thumbnail

Crawl Space Encapsulation Specialist Training at Raleigh, NC

March 19, 2019 at 9am to March 20, 2019 at 5pm
Looking to improve your crawl space encapsulation knowledge?  Join us on March 19 – 20 in Raleigh…See More
10 hours ago

© 2019   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service