We just had 2 mini split air conditioners put in our home, which previously did not have air conditioning.  We have ceiling fans in every room and I am wondering how to use the fans in conjunction with the air conditioners that are at ceiling level.  Should the fans be on summer mode?  What speed is good to use to enhance the distribution of the cool air in the rooms?  

We usually keep the fans on high to keep the air moving, but with the air conditioners, I am not sure if the warm air near the ceiling is making the compressors work more.  

Any advice out there?



Views: 632

Reply to This

Replies to This Discussion

As for direction / speed a piece I did on that - http://thehtrc.com/2014/faq-ceiling-fan-direction-summer-winter which goes from basics to common exceptions

The biggest things though to keep in mind: if your not in the room it does no good to have it on. The next is just like ducted, the unit pushes out the conditioned air which creates the mixing, it isn't up to the ceiling fan to do that while it is running

Thank you.  Good information about the ceiling fans.

Using a ceiling fan as part of a team to bring your maximum home cooling comfort. Adding a ceiling fan can allow you to actually turn up the thermostat, saving you energy and money.

Another way to conserve energy and cost is to make sure your ceiling fan is only on when the room is occupied.

Running a ceiling fan actually heats up air. Allison Bailes has some great articles on it.  I would set fans to slowest speed if you are having issues with the mini splits distributing air throughout the room. Otherwise you might be making them work harder depending on where they draw in the return air. Most units draw return air in the top and conditioned supply air out the bottom. You could be making it hard on the system by mixing the air w a fan. Try turning the fans off for a day and see if that helps.

You can run air conditioner and ceiling fan together but, if you are using it in right way then it will reduces the load on ac and even lower your cooling costs. If it is very hot then yes, you must drive a ceiling fan and air conditioning at the same time. A good ceiling fan allows the air conditioner to operate at a higher temperature. Much of the discomfort in a warm room comes from the silence in the air. A ceiling fan can relieve much of this silence. However, if you still have any more question on this then contact to White Mechanical, Inc. a professional residential HVAC services experts to get all your answers.

The big difference I see between these units and central AC in my region (Upper Midwest) is that minisplits tend to be installed up high in rooms, whereas central units are located in the basements. The mini split (if located up high) is well positioned to put cold air in at the right spot, whereas a central unit located down low has more difficulty pushing that air up as well as the registers will typically be on the floor. My experience has been that folks that have mini splits installed up high (typical) generally don't need their ceiling fans much, whereas they are  much more helpful for central systems. 

If you are using air conditioning, a ceiling fan will allow you to raise the thermostat setting about 4°F with no reduction in comfort.” If you turn on your ceiling fans, turn your air conditioner up 4 degrees to 80 degrees. The ceiling fan will keep you just as cool, at a reduced cost. However, if you have more queries on this then contact residential air conditioning installation experts at White Mechanical, Inc.

Don't use the fans! They generate heat and mix the stratified high warm air with the low cool air which is already where it needs to be (where the occupants are). Mini-split air handlers do an excellent job of moving the air and need no assistance from a paddle fan. Plus why waste the money running the fans, let the super efficient heat pump do all the work.

Now I am confused.  Everyone has a different opinion.  

This is one of thouse topic where you ask 10 people and get 12 different opinions. I will give you 5. :)

There is no clearly right answer. Some if this depends on who you are where your house is and what type of house it is.

In my opinion if you have a ceiling height over 10 feet I say the fan runs 24/7 with the AC.

If having a lower electrical bill is somewhat more important than comfort and you are willing to set your thermostat higher and turn the fan on medium as you enter and off as you exit each room. That will save you some money.

If comfort is more important than the electric bill, run the fan on low with the AC.

I find we never set the fans above the slowest speed. Between the noise and papers flying around the higher speeds are just annoying.

I find the “winter” setting spinning the blades backward makes me less comfortable and the fan soon gets turned off.




Among the various opinions expressed here, I offer a few 'truths'...

Ceiling fans are mostly for cooling PEOPLE, not rooms. Evaporative cooling. Turn off the fan when the room is unoccupied.  Walter mentions another benefit: to help mix air in rooms with volume ceilings. Whether or not that's necessary or even useful is debatable, largely depending on the home's design and mechanical system design -- both beyond the scope of this discussion I think.

Aside from evaporative cooling, ceiling fans improve comfort by disrupting the boundary layer of air that forms on the ceiling. This reduces the ceiling temperature, which in turn reduces radiant heat. This effect is greatest when you're prone, such as lying down. Even if ceiling is only a few degrees warmer than the air in the room, your body will 'feel' that in the same way you feel hot when facing a fireplace in a cold room while your backside still feels cold. 

As and aside, disrupting the air film (boundary layer) at the ceiling will slightly increase the ceiling assembly u-value (i.e., reduces R-value by a fraction). However, don't let that stop you if it allows you to raise the thermostat. Increasing the setpoint by only 1 degree will way more than offset the (tiny) additional load caused by proper air mixing.

Ceiling fans do generate heat, BUT, today's fans are far more efficient than even 10 years ago. In particular, fans with DC motors use a tiny amount of power on the lowest speed settings (some models pull as little as 3W on low!).  And with recent improvements to blade design, you get the full effect without ever turning the fan to high. Check out Energy Star's database of certified fans.

Bottom line: I strongly advocate DC ceiling fans in rooms where you spend the most time, using one of the lower speed settings. This may also help mix supply air from the mini's, but either way, there's no benefit from leaving the fan on when the room is unoccupied.

Good opinions in these replies!  I'll just add a few:

* Experiment.  It's your house and how you feel in it should drive your decisions.  If it was my house, I'd start by turning the fans off.

* There is no "best way" to go.  We don't know the size of your rooms, the layout, the insulation levels, your building airtightness, or even what climate you're in.  So all we can do is guess.

* In some of the climates where I live, ceiling fans are very helpful for moving air around, which helps avoid stale pockets, which can help keep mold at bay.  It's not just a comfort thing.

Good luck,



Forum Discussions

Blower door test for small apartment building

Started by Jerry Needham in General Forum. Last reply by John White on Friday. 9 Replies


Started by Allison A. Bailes III in General Forum. Last reply by Franco Oyuela on Thursday. 9 Replies

Radiant Barrier Southeast

Started by Gary Wright in Best Practices. Last reply by yassin chahdi on Thursday. 6 Replies

Latest Activity

Brett Little posted a discussion

How to become a Certified GreenHome Professional - Free Webinar!

The Certified GreenHome Professional (CGHP) training is a way to learn about the basics of…See More
16 hours ago
Corbett Lunsford's video was featured

Testing Air Quality with Your Nose: Control Your HOMEChem

Charlie Weschler sits down with Grace and Corbett and gives fascinating examples of the complexity of indoor air chemistry. He is an air quality legend, a professor on three continents, and a super nice guy.
Profile Iconwallace van, Tony kroos and Sunmar Construction, Inc joined Home Energy Pros Forum
John White replied to Jerry Needham's discussion Blower door test for small apartment building
"Well, I think it completely depends on the purpose and requirement of the test. Testing one unit in…"
John Nicholas replied to Jerry Needham's discussion Blower door test for small apartment building
"I can use my Duct Blaster on any house that I expect to be less than 1300 CFM through the…"
Sean Lintow Sr replied to Jerry Needham's discussion Blower door test for small apartment building
"FYI, he is in Illinois where code is 5 (well up until March as noted when it drops to 4)  Heh…"
John Nicholas replied to Jerry Needham's discussion Blower door test for small apartment building
"Here are two pictures of the duct blaster fan as a blower door.  1 in a door and 1 in a…"
John Nicholas replied to Jerry Needham's discussion Blower door test for small apartment building
"What standard are you testing to? Energy Star requires 5 ACH @ 50.   Code is 3.0 etc…"
John Nicholas replied to Jerry Needham's discussion Blower door test for small apartment building
"What standard are you testing to? Energy Star requires 5 ACH @ 50.   Code is 3.0 etc…"
Franco Oyuela replied to Allison A. Bailes III's discussion ENERGY STAR Version 3
"The ENERGY STARnew homes program has been around since the mid-1990s and is currently undergoing…"
Blake Reid commented on Blake Reid's blog post Managing Mold & Humidity (in Hawaii)
"Thank you very much! They're actually the same, though - the one with the dehu cover photo has…"
John Proctor commented on Blake Reid's blog post Managing Mold & Humidity (in Hawaii)
"Nice post -- much better than the one that only showed the dehumidifier."
Brett Little updated an event

Full Circle Urban Forestry: Introducing Urban Wood Opportunities - Free CE Webinar at Webinar Online

December 5, 2018 from 12pm to 1:15pm
Many common urban tree removal practices in the United States view felled urban trees as costly…See More
Brett Little replied to Brett Little's discussion Virtual CEU Tour of the Pembroke Passive Solar Zero Energy Ready Home
"You know utilities are pretty complex, especially in IL, however it looks like just about 6.8 cents…"
yassin chahdi replied to Gary Wright's discussion Radiant Barrier Southeast
"It’s hard to choose on of these as most of the time the reviews and buying guides found on…"
Bruce Fillmore replied to Mark Furst's discussion Bath fan weirdness
"In my opinion venting into any soffit is a bad idea, it usually requires a sharp bend to get into…"
Tray Biasiolli replied to Mark Furst's discussion Bath fan weirdness
"I'd agree with Sean - we get wind effects regularly when measuring ventilation fan intake at…"
Charles Buell replied to Mark Furst's discussion Bath fan weirdness
"You would have to test the vent at the inside at a location the same diameter as the outside…"
Blake Reid's blog post was featured

Managing Mold & Humidity (in Hawaii)

A blower door measures how tight a house isAir sealing done as part of the install, and after…See More
John White replied to Cameron Home Insulation's discussion Why is Air Sealing Important?
"Most attics have insulation which helps reduce heat loss. But it won't stop the air flow.…"


  • Add Photos
  • View All

© 2018   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service