Hello pros.

Please see the attached pictures.

Any insights on how you would insulate the 2nd story walls of this house? The house is located in the suburbs of Washington D.C.

Thanks!

Patrick

Views: 4920

Reply to This

Replies to This Discussion

Mr. Poll,

I'd take your list for our climate and edit it down to:

4.  As always with ice dams, air sealing and insulation are the first concerns.  Once that is done, then venting can be addressed.

6. Air tightness test and IR can your insulation and air barrier work. If good, drywall.

5. Ignore venting especially in lower slopes.

Have done a few of these in my time. Not easy, but can be done. I have taken 2 rows of shingles off, difficult because you have to get nails from not only the course you want to remove, but also, the row above that. Once the row is removed, I cut a 3 inch square out of the top of the course that is showing and keep that to be replaced. Drill your holes, fill with cellulose, install a tapered wooden plug, cover the plug with roof tar, replace the square you cut out earlier, cover this with a thin coat of roof tar, reinstall your shingle. Labor intensive, but I have had great success with it. Good luck.

Robert

It seems that you describe filing the entire cavity between the vertical interior wall and the steeply pitched lower roof with insulating material - is this correct?  How much insulation is this?  How do you ensure that you have sealed the open joist cavity ends?  In some of these built in recent times, we have seen the plywood interior subfloor extend out to the steeply angled roof so that filling the cavity with insulation does not address the open cavities - and these are the biggest problem with this type of mansard.  Second biggest problem in this particular case is the open party wall at both ends of the house (In this case, just one end because it is an end-row unit).  This open party wall would need some dense-packing.  Both the party wall and the joist cavities are the source of all the moisture that might be in the lower attic - in this DC climate.

You could then drill a 1 inch hole thru the soffit and fill the open end of the floor joists. If the soffit is large enough, drill your normal sized hole and fill it, plug, and patch. You can expect to go thru alot of material as the lower portion flairs out. Anything can be done, only limitations are your comfort levels.

Yikes. It is never as straightforward as one would hope in these "do it right" retrofits. The homeowner is getting itchy about implementing the work, especially because he has been given much misinformation (so it appears) from other "blow it and roll" contractors.

I may have to walk away from this one if he feels confident enough to just settle with more insulation is better than no insulation.

Patrick

Ed,

You put your finger on it: air seal floor cavity! The volume is triangular and the weight and force with dense pack will be borne by the soffit. I love cellulose, but may be best to open it up from below (or if re-roofing pull back the sheathing), do some air sealing and ensure your duct runs are"inside" the house.

Robert,

Very good idea. I have experience with patching roofs and re-roofing so that part will not be a problem.

Much preferred to the going through drywall route, and later having to patch and paint.

Happy holidays!

Patrick

Ok, What has happened since? 

RSS

Forum Discussions

What made this chimney fall down?

Started by Eric Kjelshus in General Forum. Last reply by Eric Kjelshus on Tuesday. 7 Replies

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by Dave Taylor Nov 11. 61 Replies

Manual J (SD) for custom, luxury homes

Started by Dav Camras in HVAC. Last reply by Dav Camras Nov 10. 3 Replies

Quantitative methods for residential zoning

Started by Brett in HVAC. Last reply by David Butler Nov 9. 1 Reply

Home Energy Pros and #MeToo

Started by Mike Rogers in General Forum. Last reply by Mike Rogers Nov 9. 3 Replies

Latest Activity

Profile IconSonny Roncancio and Chester Energy & Policy joined Home Energy Pros Forum
11 hours ago
Ryan Moore updated an event
Thumbnail

LEED for Homes Green Rater Training at Fort Collins, CO

December 7, 2017 to December 8, 2017
Green Insight will host this 2-day training in Fort Collins, CO December 7-8,…See More
yesterday
Rodney Bailey liked Rodney Bailey's discussion Energy audit equipment for sale.
yesterday
tedkidd liked Mike Rogers's blog post Focusing on payback to motivate customers?
yesterday
Home Energy Magazine's blog post was featured
Wednesday
Home Energy Magazine posted a blog post
Wednesday
Quinn Korzeniecki added a discussion to the group Building Performance Institute (BPI)
Thumbnail

Rebates and Incentives: Illinois

Curious about home performance incentives and rebates available in your area? Check out this BPI…See More
Wednesday
Profile IconStacey Cordeiro and Melissa Ames joined Home Energy Pros Forum
Wednesday

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service