Are there suggestions out there as to the best way to insulate newly installed speakers!  I have been working to improve the  tightness of my 22 year old home but after that big effort, I installed 10 speakers in 5 rooms.  This, as one might suspect, has resulted in several holes leading from unconditioned spaces to conditioned spaces. Some folks say just drape insulation over the new speakers while other say build a box to protect the innards of the speakers from fiber glass, dust, etc. The latter is supposed to enhance the quality of the music emanating from the speakers but there are many opinions out there!

Views: 24560

Reply to This

Replies to This Discussion

From techstreet -- holder of some of the UL documents.... about UL-1715

"This test method is intended for use in the evaluation of the flammability contribution of wall materia l assemblies, ceiling material assemblies, or both, exposed to early fire growth under specified room fir e exposure conditions. The effectiveness of fire barrier materials as protection for other combustible materials or components within the assembly is of primary interest for this evaluation."

The point of suggesting to look for UL1715 and the ASTM numbers is that it might be that other good building materials would be found that could do a better job for John.  That was the reason for suggesting keywords for searches.

The Tenmat hats themselves provide the flame spread,  the fire stop foams/sealants, just cover the cases where flames might seep under the hats and into the attic.   They also stop the hats from rattling and dancing around in the attic when loud rock and roll is played  :-)

good point on the dancing. 

my only concern is that folks dont get the impression there are fire safe foam's out there.  if you ignite an piece of FS 25 foam and take the flame source away, the foam will self extinguish.  But, the tech data sheets the foam manufacturers provide will have footnotes saying their foam requires a 15 minute thermal barrier between the foam and the people.  that's becasue foam has a low self ignition temperaturte, and it is very good at holding heat in.  it doesn't take long for foam to burn when it is exposed to heat in excess of 450 degrees. 

RSS

Forum Discussions

What made this chimney fall down?

Started by Eric Kjelshus in General Forum. Last reply by Eric Kjelshus on Tuesday. 7 Replies

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by Dave Taylor Nov 11. 61 Replies

Manual J (SD) for custom, luxury homes

Started by Dav Camras in HVAC. Last reply by Dav Camras Nov 10. 3 Replies

Quantitative methods for residential zoning

Started by Brett in HVAC. Last reply by David Butler Nov 9. 1 Reply

Home Energy Pros and #MeToo

Started by Mike Rogers in General Forum. Last reply by Mike Rogers Nov 9. 3 Replies

Latest Activity

Profile IconSonny Roncancio and Chester Energy & Policy joined Home Energy Pros Forum
8 hours ago
Ryan Moore updated an event
Thumbnail

LEED for Homes Green Rater Training at Fort Collins, CO

December 7, 2017 to December 8, 2017
Green Insight will host this 2-day training in Fort Collins, CO December 7-8,…See More
yesterday
Rodney Bailey liked Rodney Bailey's discussion Energy audit equipment for sale.
yesterday
tedkidd liked Mike Rogers's blog post Focusing on payback to motivate customers?
yesterday
Home Energy Magazine's blog post was featured
Wednesday
Home Energy Magazine posted a blog post
Wednesday
Quinn Korzeniecki added a discussion to the group Building Performance Institute (BPI)
Thumbnail

Rebates and Incentives: Illinois

Curious about home performance incentives and rebates available in your area? Check out this BPI…See More
Wednesday
Profile IconStacey Cordeiro and Melissa Ames joined Home Energy Pros Forum
Wednesday

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service