Are there suggestions out there as to the best way to insulate newly installed speakers!  I have been working to improve the  tightness of my 22 year old home but after that big effort, I installed 10 speakers in 5 rooms.  This, as one might suspect, has resulted in several holes leading from unconditioned spaces to conditioned spaces. Some folks say just drape insulation over the new speakers while other say build a box to protect the innards of the speakers from fiber glass, dust, etc. The latter is supposed to enhance the quality of the music emanating from the speakers but there are many opinions out there!

Views: 24574

Reply to This

Replies to This Discussion

From techstreet -- holder of some of the UL documents.... about UL-1715

"This test method is intended for use in the evaluation of the flammability contribution of wall materia l assemblies, ceiling material assemblies, or both, exposed to early fire growth under specified room fir e exposure conditions. The effectiveness of fire barrier materials as protection for other combustible materials or components within the assembly is of primary interest for this evaluation."

The point of suggesting to look for UL1715 and the ASTM numbers is that it might be that other good building materials would be found that could do a better job for John.  That was the reason for suggesting keywords for searches.

The Tenmat hats themselves provide the flame spread,  the fire stop foams/sealants, just cover the cases where flames might seep under the hats and into the attic.   They also stop the hats from rattling and dancing around in the attic when loud rock and roll is played  :-)

good point on the dancing. 

my only concern is that folks dont get the impression there are fire safe foam's out there.  if you ignite an piece of FS 25 foam and take the flame source away, the foam will self extinguish.  But, the tech data sheets the foam manufacturers provide will have footnotes saying their foam requires a 15 minute thermal barrier between the foam and the people.  that's becasue foam has a low self ignition temperaturte, and it is very good at holding heat in.  it doesn't take long for foam to burn when it is exposed to heat in excess of 450 degrees. 

RSS

Latest Activity

Jonathan Beers posted a discussion

MGE hiring for my job

I'm retiring next spring, and MGE is hiring:…See More
15 hours ago
Summer Reyes's blog post was featured

Equipment We Use: Detecting Water With Infrared Cameras

You know water is somewhere on the property, you can smell the mildew, but can't determine the…See More
17 hours ago
Profile IconGlenn Hourahan and Joseph Frasier joined Home Energy Pros Forum
17 hours ago
Alfredo Baccari added a discussion to the group Job Board
Thumbnail

HERS or/and BPI Energy Inspector in SF Bay Area (SAN JOSE, CA).

ELEM3NTS is a leading energy efficient consulting company specializing in residential homes. We…See More
18 hours ago
Alfredo Baccari joined Diane Chojnowski's group
Thumbnail

Job Board

This group is for posting jobs related to all aspects of the home performance industry including…See More
19 hours ago
David Byrnes's blog post was featured

Strategies for Hiring and Interviewing for Home Performance Professionals

Hire slow and fire fast.  It’s a phrase that experienced managers and human resources professionals…See More
21 hours ago
Dara Bowser replied to Don Fugler's discussion joining ducts in the group HVAC
"Good to hear you have clean dryer ducts Don. The dryer duct issues that we run into are…"
yesterday
Don Fugler replied to Don Fugler's discussion joining ducts in the group HVAC
"David, If the IMC mandates metal dryer duct and prohibits metal screws, they must be accepting…"
yesterday

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service