NAR's public consumer advocacy website is HouseLogic. This month they are featuring an interesting twist to increase consumer interest in energy efficiency makeovers.  They've done some fantasy-inspired estimates for three big energy efficiency imp...

Fantasy aside, not sure I would replace historic windows, and for the average real house, today, in the US, the payback for insulation and air sealing would sure be a lot higher.

Interesting way to get the conversation started though!  What do you think about the story?

Tags: energy, estate, home, improvement, real

Views: 802

Reply to This

Replies to This Discussion

The Downtown Abbey HEP Partnership - I'm in

I calculate the saving for a 1x3m. single glazed window using the Glass and Glazing Federation's calculator at about £28 per annum which seems about right. I don't see how where the $274 figure comes from?

Interesting.  Can you send me the link you used?  Methinks their math is way off somewhere! Thanks.

 

Personally I don't think costs are a good way to evaluate overall efficiency.

For a building like this it will never be 'efficient', too many windows so a solution is to supply its heat w/o using the grid and that's fairly easy using thermal-fluids and storing them in insulated tanks for use on-demand to warm a room.

This means no grid power is needed to heat the whole building, one wouldn't necessarily need to replace the windows for this particular case.

So this would take some trough collectors on the roof heating the thermal-fluid system, it's similar to using steam except with the fluids they don't boil and don't freeze so the drawback is pumping as a need for power but none needed for the heat.

Doing this means the "costs" of heating the building will be the capital costs amortized over the payback and a small amount for maintenence, huge difference looking at it this way to pay-by-the-watt heating even with new windows.

 

Tom

Is there enough roof area on this "whole building" to come close to supplying enough BTU's?  Is there enough acreage on the estate to do that??  How many millions of BTU's per hour is needed?  If the building is 40,000 ft2, and it loses 30,000 BTU/ft/season - that is over a billion (with a B) BTU in a season.  

Maybe it has it's own coal seam on the property, or maybe their 1,000 acres of woods could come into play.

Next to impossible to make this efficient on any level. Reduce, reuse, recycle. Reusing and recycling the existing building materials may be the way to go.....from an energy efficiency perspective....

This building is a great example of something so lossy it really should get some solar-gain into the equation, some alternative to collect solar-thermal stored to use for the daily cycle and get off the need to burn anything for heat most of the year.

As a practical matter probably the only major efficiency measure would be air sealing. I bet there would be some good opportunities.

How many truck mounted blower-doors would it take to test that place? Think of the effort just to check the doors and windows and make sure all the interior doors were open. And the fireplaces covered.

The calculator is here:- http://www.ggf.org.uk/energy-savings-calculator. It uses metric units.

This problem requires a pragmatic approach. My suggestions in order are:-

1. The installation of a biomass heating boiler system for heating using the estate renewable timber resource.

2. A solar hot water system probably roof mounted.

3. Gradual replacement of the glazing units with slimline warm edged DG units - 11-14mm. thick.

4. Attention to drafts at windows, chimneys, etc.

There probably isn't much scope for internal upgrading of wall insulation in this case but in other situations thin insulation systems such as Multifoil or Spacetherm can be used provided extra attention is given to ventilation of the existing structure.

RSS

Forum Discussions

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler yesterday. 2 Replies

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco yesterday. 1 Reply

Fixing a water heater?

Started by John Shillito in Best Practices. Last reply by Eric Kjelshus on Friday. 21 Replies

Latest Activity

Profile IconAvery T. Phillips, Sarah Burger, Troy Spindler and 2 more joined Home Energy Pros Forum
7 hours ago
David Butler replied to Brad Cook's discussion Too many Heat Pump Water Heaters in a basement?
"theoretically, let's say you perfectly isolate the HPWH from a heat source. The HPWH's…"
yesterday
David Butler replied to David Butler's discussion How would you insulate this roof?
"Interesting idea. Commercial roof on a slope! Typical density for roofing spray foam is 2.5 to 3.0…"
yesterday
Profile IconRandy Kinnison, Breanna Detwiler, Jeff Farlow and 7 more joined Home Energy Pros Forum
yesterday
Summer Redman added a discussion to the group Job Board
Thumbnail

Hiring 2 Training Specialists in Champaign-Urbana, Illinois

The Applied Research Institute (ARI) at the University of Illinois at Urbana-Champaign is seeking…See More
yesterday
Summer Redman joined Diane Chojnowski's group
Thumbnail

Job Board

This group is for posting jobs related to all aspects of the home performance industry including…See More
yesterday
Stacie Bagnasco replied to Evan Mills's discussion Dirty solar panels
"This is a great idea. I clicked on your discussion because it made me remember that I forgot to get…"
yesterday
Kirsten Richnavsky posted an event
Thumbnail

rCloud - The Future of Testing at Your Office or Home

October 18, 2017 from 2pm to 3pm
Integrating rCloud as an essential part of your RESNET QA process.Retrotec’s rCloud app is here,…See More
yesterday

Photos

Loading…
  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service