How to keep mice, critters from getting into duct insulation that is under a house that is on piers.

How do you keep mice, critters from getting into duct insulation that is under a house that is on piers?

Views: 2284

Reply to This

Replies to This Discussion

A former owner where I did some repair work had evidently tried to keep the rodents out by nailing a flattened tin can over their entrance. Mice or rats I never determined, but they chewed right through that makeshift cover and continued to use the rafters as they wished. 

At a minimum I would recommend T&G plywood and hope they wouldn't be able to detect any warmth from above.  When the cold season comes they would make short work of 3/4" plywood.

There are some concrete based 4'x8' panels that besides being heavy might be better at keeping them out.  Of course mice will be a lot easier to stop than their larger cousins.

An abundance of traps to eliminate them before they start chewing their way in is always a good defense.  I try to avoid poisons and local domestic animals might be affected.

Bud

If your ducts are below the bottom sheathing I would wrap them or box them in with metal.

The ducts are below the floor and above the dirt under the houses. It sounds difficult and expensive to wrap them or box them in with metal.

mothballs have worked for decades

You have to keep it out of their reach thus a Sealed crawl is the best option

For a vented crawl, make sure all your insect & rodent proofing is in place also; Using flex duct is not recommended, nor fiberboard, just metal ducts sealed with insulation on the outside. Better to have to make a few cosmetic repairs occasionally then let them get into the system.

If an existing issue, how are they getting in, in some cases it is from above & that needs to be dealt with also: http://blog.sls-construction.com/2010/safety-sunday-rodent-prevention

We have used hardware cloth (1/4" mesh wire) and then sprayed it with single part foam. I have heard of used cat litter (urine smell) sprinkled about and moth balls as other options.

RSS

Forum Discussions

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by Brad Cook 3 hours ago. 27 Replies

Psychrometric Chart Training

Started by John Krochmalny in Training. Last reply by Mahendra Shah on Friday. 1 Reply

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco Oct 16. 1 Reply

Latest Activity

Brad Cook replied to David Butler's discussion How would you insulate this roof?
"Bill, you just posted a number of responses in different areas of the thread. I will try to respond…"
3 hours ago
Donald Hester liked Marc Tannenbaum's blog post 3 Issues HVAC contractors Should Know About Impacting Customer Comfort and Health
3 hours ago
Profile IconAlice Quinn and Donald Hester joined Home Energy Pros Forum
4 hours ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"In an earlier response, I noted that we COULD haul drinking water and use the water we collect off…"
4 hours ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"As to the elevations on the cupola – the existing windows up there might survive adding…"
4 hours ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"The purlins are 1 3/4" thick. I believe the top chord of the trusses are 10" deep (but…"
4 hours ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"The cupola windows are the only place there would be a problem if 4" of foam were added above…"
4 hours ago
Bill Spikowski replied to David Butler's discussion How would you insulate this roof?
"The purlins are 1 3/4" thick. I don’t know about the fire dangers of PIC or other foams.…"
4 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service