http://www.atlassales.com/products/heati...2oach1211/

Go to the section near the bottom for stats on Heat Pump design.

Views: 376

Reply to This

Replies to This Discussion

How about a better, easier to use link?

I received a "page not found" error" and then a page with hundreds of links, like a table of contents

I can't change that Curt but if you click on the section for Heat Pumps it will have what I count as a good design for Office conditions.

OK, a  portable 1 ton heat pump AC. That's nice, but what's your point?

I imagine that puppy is fairly noisy, and unlikely to be anywhere near as efficient as a fixed system; certainly not a permanent solution.

Why are you posting it here? Is this a backhanded way of advertising your wares? That would seem to abuse the purpose of this site.

No Curt it is to solve a big problem that does occur on the top floors of Commercial buildings being too hot or too cold. I do not endorse or make money of any of these products. Most HVAC systems are combined on a roof and that creates a problem also. I am not here to argue with any individuals and only want to point out solutions.

Fair enough

The big issue I see with this unit is where to exhaust the condenser discharge. Most commercial buildings don't have operable windows.

If the space above the ceiling tile is used as a common return then the condenser will work fine

Dale,

Do you propose to exhaust portable air conditioners' rejected heat (hot air) into the volume above a typical office drop ceiling?

only if its being used as a return air cavity (very common)

RSS

Latest Activity

David Butler replied to Don Fugler's discussion joining ducts in the group HVAC
"Static pressure drop through a straight length of pipe is a function of friction rate, and friction…"
52 minutes ago
Sean Wiens replied to Don Fugler's discussion joining ducts in the group HVAC
"Apparently the air passing over the PVC creates a strong static field that in turn impedes air flow."
1 hour ago
David Butler replied to Don Fugler's discussion joining ducts in the group HVAC
"Why would you think PVC has high resistance?"
1 hour ago
Sean Wiens replied to Don Fugler's discussion joining ducts in the group HVAC
"Thanks David - I was going to look at PVC for the HRV but was cautioned against it, not because of…"
1 hour ago
David Butler replied to Don Fugler's discussion joining ducts in the group HVAC
"Great post, Sean. I agree that screws are wise when joining metal ducts, but its also true that…"
2 hours ago
David Butler posted a discussion

Welcome Home Performance Forum Members (formerly RESNET BPI - Energy Audit and Home Performance)

Last month the Home Performance Forum merged with Home Energy Pros, now under the Home Performance…See More
2 hours ago
Sean Wiens replied to Don Fugler's discussion joining ducts in the group HVAC
"Various studies have indicated very little air flow along surface of duct (for ventilation - have…"
3 hours ago
Dara Bowser replied to Don Fugler's discussion joining ducts in the group HVAC
"Hi Don. We have never considered screws as impeding airflow, but I can see how in some ducts (e.g.…"
4 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service