http://www.atlassales.com/products/heati...2oach1211/

Go to the section near the bottom for stats on Heat Pump design.

Views: 372

Reply to This

Replies to This Discussion

How about a better, easier to use link?

I received a "page not found" error" and then a page with hundreds of links, like a table of contents

I can't change that Curt but if you click on the section for Heat Pumps it will have what I count as a good design for Office conditions.

OK, a  portable 1 ton heat pump AC. That's nice, but what's your point?

I imagine that puppy is fairly noisy, and unlikely to be anywhere near as efficient as a fixed system; certainly not a permanent solution.

Why are you posting it here? Is this a backhanded way of advertising your wares? That would seem to abuse the purpose of this site.

No Curt it is to solve a big problem that does occur on the top floors of Commercial buildings being too hot or too cold. I do not endorse or make money of any of these products. Most HVAC systems are combined on a roof and that creates a problem also. I am not here to argue with any individuals and only want to point out solutions.

Fair enough

The big issue I see with this unit is where to exhaust the condenser discharge. Most commercial buildings don't have operable windows.

If the space above the ceiling tile is used as a common return then the condenser will work fine

Dale,

Do you propose to exhaust portable air conditioners' rejected heat (hot air) into the volume above a typical office drop ceiling?

only if its being used as a return air cavity (very common)

RSS

Forum Discussions

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler 12 hours ago. 34 Replies

Psychrometric Chart Training

Started by John Krochmalny in Training. Last reply by Mahendra Shah on Friday. 1 Reply

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco Oct 16. 1 Reply

Latest Activity

Profile IconCharles Buell, Robert Cowell, Alice Quinn and 1 more joined Home Energy Pros Forum
4 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"Sean Lintow proposed rails and clips (re: first comment in this discussion), but in the context of…"
12 hours ago
Brad Cook replied to David Butler's discussion How would you insulate this roof?
"I missed where the suggestion for rails came in. The plywood would not need any rails. 4+ inches is…"
17 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"I'm a little confused about the necessity and purpose of using support rails if working on…"
17 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"If you insulate master bedroom and family room from below, you definitely need more R-value than…"
17 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"Brad, I was only talking about using EPS between the ridges, if necessary, to conform to bolts.…"
17 hours ago
Brad Cook replied to David Butler's discussion How would you insulate this roof?
"It kind of depends on the PIC. Not all insulation is made the same. Here in VT (and all of New…"
17 hours ago
David Butler replied to David Butler's discussion How would you insulate this roof?
"Filling those shallow valleys with rigid foam not only prevents primary foam panels from…"
18 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service