Hi All,

I am trying to figure out a good flow grid system to use for testing airflow in 2 to 5 ton forced air systems.

Any favorites?

Or, if you prefer a flow-hood, please tell my why.

The flow hoods I've used take up more space in my vehicle than I would like.

Thanks for your thoughts.

George

Tags: flow, hoods, tools

Views: 206

Reply to This

Replies to This Discussion

I have 3 hoods - low flow ( 10-500 CFM)  Med flow (40-1500 CFM)  high flow (50-2000CFM) Open grid  for kitchen hoods. Plus hot wire plus presser plus other testing tools.   I test the air flow 3 ways  on each major job just to make my point or so I do not mess up.    Flow hoods have been used for 70 years and there's a lot of groups to help get it right.   look at http://www.trutechtools.com ,  www.nationalcomfortinstitute.com,  www.nebb.org,  https://www.aabc.com/www.tabbcertified.org.  I hope this helps some 80% air systems do not have the air flow to keep the unit on high limit.  

Thanks Eric!

Assuming that you're mainly interested in the total air handler flow, and you have access to the filter slots, I'd suggest looking at Energy Conservatory's TrueFlow.  It's a flat plate with openings; it has adapter plates for a variety of filter slot sizes. You'll also need to drill a hole in the supply plenum (or otherwise get a pressure tap in there).

  http://www.energyconservatory.com/products/trueflow%C2%AE-air-handl...

I like the flat true flow plate when it fits-  if not the by pass is very very large.   Or if the presser is to high  its off some.   I have used 4 True flow plates  on a 2 ton spit system to find air flow.    Quick way is just use paper work that comes with the air handler ( you know the knee pad that come with the unit)  find the right unit using the right MO #  then total CFM reading the fan performance data at a constant speed chart.  to find Total SP use your blower door meter with a SP gauge both side of  motor, 3 of 10 will be off with high turbulence.  Have some fun with it and write about it I will be looking for your comments. 

If you wanted more information on the TrueFlow plate, the manufacturer is offering a webinar on it today: https://events-na11.adobeconnect.com/content/connect/c1/1097690081/...

RSS

Latest Activity

Dannie Jackson liked Allison A. Bailes III's group HVAC
8 hours ago
Dannie Jackson added a discussion to the group Energy Efficient Design
8 hours ago
Dannie Jackson liked Barry NewDelman's discussion Help your Clients save, THEN do what you do best
9 hours ago
Dannie Jackson replied to Barry NewDelman's discussion Whats the Consensus of this group Define "Energy Efficiency" in the group Energy Efficient Design
"Design wise I would say that energy efficiency is defined by the Btu / square foot.  This is…"
9 hours ago
Dannie Jackson joined Chris Laumer-Giddens's group
Thumbnail

Energy Efficient Design

Energy efficiency starts at the drafting table...How architects and designers can help buildings…See More
9 hours ago
Dannie Jackson liked Chris Laumer-Giddens's group Energy Efficient Design
9 hours ago
Dannie Jackson posted a blog post
10 hours ago
Dannie Jackson liked Home Performance Coalition's blog post Building a Market for High-Performing Homes
11 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service