Wondering if anyone has any feedback on the combustion analyzers that have integrated pressure measurements. I am getting ready to move to two crews and do not want to buy a separate manometer as we may be doing combustion tests separately from the job date.

I am looking at the TPI 708 for $336 at professional equipment

Thanks!

Views: 385

Reply to This

Replies to This Discussion

I just looked at the specs. What I couldn't determine was the draft measure increment. Here's what I do know about the Bacharach and Testo Analyzers. They round to the nearest pascal for draft. As we in NY use the BPI protocols, this can lead to a false positive. In other words you calculate that minimum draft for the outside temperature is -1.9 pascals, the combustion analyzer may measure the draft at -1.6 and ROUND DOWN to -2 pascals. I have seen this happen.

I understand the expense of purchasing more equipment, I see your supplier has a couple of manometers for under $200, I'm not familiar with them, but they may be worth taking a look at. Manometers

The other option with I have not experimented with is using the combustion analyzer and testing draft in I.W.C. and then converting to pascals.

I have a Testo and Bacharach  that reads in Inch of water.   Its ok to poor but not as use-full as  you think.    I like to make 2 holes in the flue and use one with a high end manometer and other flue gas  02, CO2,  temp, O.    To read draft I must change screens + turn off then back on and that takes time- or does not happen at right time.  The draft changes with flue temp and how cold the outside is and presser of the furnace/boiler room.  I like to see when starts to draft up the flue.   I like to see a High end low level  CO ( carbon monoxide meter ) with each teck artisan and just put on tool box.   Last boiler I worked on was putting out 2000 PPM CO and the meter was to slow to pick high numbers.  99% of HVAC teck artisan use inch water not pascals.  My use of a hand held CO meter helps me keeping save.    You can use a cheap draft gauge better than meter with draft gauge 

RSS

Latest Activity

Profile IconSean Wiens and David Butler joined Chris Laumer-Giddens's group
Thumbnail

Energy Efficient Design

Energy efficiency starts at the drafting table...How architects and designers can help buildings…See More
8 hours ago
Profile IconSean Wiens and David Butler joined Mark Richardson's group
Thumbnail

Renewable Energy

This group will focus on the issues associated with incorporating renewable energy sources like…See More
8 hours ago
Al Tibbs posted photos
9 hours ago
Al Tibbs replied to Bob Krell's discussion What Do You Do When You Find Suspected Mold? in the group Healthy Indoors (IAQ)
"In any case where there is visible mold present, I would begin with a thorough VISUAL assessment of…"
9 hours ago
Al Tibbs joined Bob Krell's group
Thumbnail

Healthy Indoors (IAQ)

The Healthy Indoors group is focused on indoor air quality (IAQ), mold, moisture control, radon,…See More
9 hours ago
David Byrnes posted a blog post

Strategies for Hiring and Interviewing for Home Performance Professionals

Hire slow and fire fast.  It’s a phrase that experienced managers and human resources professionals…See More
10 hours ago
David Butler posted discussions
10 hours ago
David Butler replied to Don Fugler's discussion joining ducts in the group HVAC
"Static pressure drop through a straight length of pipe is a function of friction rate, and friction…"
15 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service