I've read about problems with blowing smoke into duct systems to find leaks. One article said that the smoke product left some bad residue inside the system.

 

Does anyone have a good product/system/technique to recommend to find elusive duct leaks while "doing no harm?"

Thanks

Views: 1936

Reply to This

Replies to This Discussion

I would call or email the Energy Conservatory. They have some very knowledgeable folks there would will know what's current on this. Let us know what you find out.

I bought a theatrical fogging machine.  I was really jazzed about using the fogger from everything I read about it was pretty cool, non toxic, fog evaporates relatively quickly, no odor and leaves little residue by the machine.  Well opening the order I discovered the machine did not include the fogging solution!  Big bummer, I had to order the fogging solution.  I will let you know how it works  and if I wasted my money or not.  If any one of these machines  can you let me know any experiences, good or bad!

Thanks

Mike

I have not found it to be very helpful and have tried on a number of occasions with a  theatrical fog machine.  If it is a big leak or at the air handler, then you can see some smoke.  If the leaks are at fittings and connections, by the time the air moves through the insulation layer, it is scrubbed of smoke.  Limited lighting in attics and crawlspaces just adds to the difficulty.  If you were working in with uninsulated metal ducts, I can see where it might be helpful.  For the ductboard and flex ducts I typically see it has been more wasted effort than helpful.

 

I have found the hand held Wizard Stick smoke wand to much more helpful.

   Theatrical fog is the same stuff you put in kids' electric trains to make the steam engine "steam."  It's also the same "juice" we put in our Wizard Sticks (another kids' toy, and a much better choice than the titanium tetrachloride in smoke sticks if testing is being done in an occupied house).

    Two lessons about theatrical fog:  (1) put plastic bags over any activated smoke detectors  and (2) buying the fog juice online gets expensive because of the shipping.  Check local music stores.  If they sell electric guitars and amplifiers the odds are good that the sell fog juice.

I will use the fog on occasions to either impress homeowners and contractors on leaky systems. It has helped find the really big airholes. I have to admit I was stumped last time, I used the fogger on a duct system that I could not get any pressure on. I had guys in crawlspace and house, very little fog made it to registers. Did some more investigating... when the original hvac was installed, the contractor built a closet for the return where the old gas furnace had been, using existing walls, etc. HE INCLUDED THE PREEXISTING CHIMNEY, UNSEALED, into the return cabinet!  The fog was going up and out the abandoned chimney! ARRRRGH. Gotta go and find some more airholes!

RSS

Forum Discussions

How would you insulate this roof?

Started by David Butler in General Forum. Last reply by David Butler yesterday. 2 Replies

Dirty solar panels

Started by Evan Mills in General Forum. Last reply by Stacie Bagnasco yesterday. 1 Reply

Fixing a water heater?

Started by John Shillito in Best Practices. Last reply by Eric Kjelshus on Friday. 21 Replies

Latest Activity

Profile IconAvery T. Phillips, Sarah Burger, Troy Spindler and 2 more joined Home Energy Pros Forum
5 hours ago
David Butler replied to Brad Cook's discussion Too many Heat Pump Water Heaters in a basement?
"theoretically, let's say you perfectly isolate the HPWH from a heat source. The HPWH's…"
yesterday
David Butler replied to David Butler's discussion How would you insulate this roof?
"Interesting idea. Commercial roof on a slope! Typical density for roofing spray foam is 2.5 to 3.0…"
yesterday
Profile IconRandy Kinnison, Breanna Detwiler, Jeff Farlow and 7 more joined Home Energy Pros Forum
yesterday
Summer Redman added a discussion to the group Job Board
Thumbnail

Hiring 2 Training Specialists in Champaign-Urbana, Illinois

The Applied Research Institute (ARI) at the University of Illinois at Urbana-Champaign is seeking…See More
yesterday
Summer Redman joined Diane Chojnowski's group
Thumbnail

Job Board

This group is for posting jobs related to all aspects of the home performance industry including…See More
yesterday
Stacie Bagnasco replied to Evan Mills's discussion Dirty solar panels
"This is a great idea. I clicked on your discussion because it made me remember that I forgot to get…"
yesterday
Kirsten Richnavsky posted an event
Thumbnail

rCloud - The Future of Testing at Your Office or Home

October 18, 2017 from 2pm to 3pm
Integrating rCloud as an essential part of your RESNET QA process.Retrotec’s rCloud app is here,…See More
yesterday

Photos

Loading…
  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service