Craig Bird's Discussions (96)

Discussions Replied To (69) Replies Latest Activity

"I agree with Jason. Zoho CRM is amazing and cheap. You can also easily use their web…"

Craig Bird replied Apr 19, 2012 to Inexpensive CRM Software for Energy Auditing & Sales

14 Apr 20, 2012
Reply by Craig Bird

"This is in Tucson. It is a 1300 square foot, built 1972, slump block, flat roof home…"

Craig Bird replied Apr 18, 2012 to Insulating flat roof with 7" cavity with roof tear-off

13 Apr 20, 2012
Reply by Christopher Retzler

"Not sure of your point in regards to leaving a space. Cavities are filled with foam…"

Craig Bird replied Apr 18, 2012 to Insulating flat roof with 7" cavity with roof tear-off

13 Apr 20, 2012
Reply by Christopher Retzler

"Talking about insulating the roof, not coating stuff on top. The ducts are contained…"

Craig Bird replied Apr 18, 2012 to Insulating flat roof with 7" cavity with roof tear-off

13 Apr 20, 2012
Reply by Christopher Retzler

"We would not fill rafter completely due to cost. Foam = expensive and you hit dimini…"

Craig Bird replied Apr 18, 2012 to Insulating flat roof with 7" cavity with roof tear-off

13 Apr 20, 2012
Reply by Christopher Retzler

"Problem is Ice Dams.  The home most likely had melting of roof snow which then refro…"

Craig Bird replied Apr 17, 2012 to BPI's April Stump the Chump: What’s Wrong with this Picture?

3 May 15, 2012
Reply by Cierra Mooney

"Some initial concerns over the approach were radiant heat buildup in the air space i…"

Craig Bird replied Apr 17, 2012 to Insulating flat roof with 7" cavity with roof tear-off

13 Apr 20, 2012
Reply by Christopher Retzler

"I have sealed this before. IMO, it would be easier to run two beads of caulk on each…"

Craig Bird replied Feb 16, 2012 to Fix this leakage?

2 Feb 16, 2012
Reply by Bud Poll

"Thanks Ed, typically don't have a problem with low end of roof as the run is usually…"

Craig Bird replied Jan 30, 2012 to Capping/air sealing, insulating dropped ceilings

4 Jan 31, 2012
Reply by Ed Minch

"I think the original premise of this thread has gotten pushed aside. I am talking ho…"

Craig Bird replied Jan 27, 2012 to Insulating a garage in hot dry climate?

8 Feb 3, 2012
Reply by Alexander Bell

RSS

Latest Activity

Don Fugler replied to Don Fugler's discussion joining ducts in the group HVAC
"David, If the IMC mandates metal dryer duct and prohibits metal screws, they must be accepting…"
36 minutes ago
David Butler replied to Don Fugler's discussion joining ducts in the group HVAC
"I never checked that before. Checking now... Section M1502.4.2 of the International Residential…"
47 minutes ago
Joseph Frasier is now a member of Home Energy Pros Forum
47 minutes ago
Don Fugler replied to Don Fugler's discussion joining ducts in the group HVAC
"Brendan, Thanks for that response. Because of your warning, I just went down to the basement and…"
4 hours ago
Brendan Reid replied to Don Fugler's discussion joining ducts in the group HVAC
"Hi Don, Summary: DRYER VENT: screws bad idea, possibly prohibited by code. METAL DUCT: must be…"
5 hours ago
Profile IconBrendan Reid and David Butler joined Allison A. Bailes III's group
Thumbnail

HVAC

HVAC design, Manuals J, S, T, & D, Duct leakage, Air flow, ENERGY STAR new home requirements,…See More
5 hours ago
Profile IconSean Wiens and David Butler joined Chris Laumer-Giddens's group
Thumbnail

Energy Efficient Design

Energy efficiency starts at the drafting table...How architects and designers can help buildings…See More
13 hours ago
Profile IconSean Wiens and David Butler joined Mark Richardson's group
Thumbnail

Renewable Energy

This group will focus on the issues associated with incorporating renewable energy sources like…See More
13 hours ago

Photos

  • Add Photos
  • View All

© 2017   Created by Home Performance Coalition (HPC)   Powered by

Badges  |  Report an Issue  |  Terms of Service